ZyXEL Communications metrogigabit switch manual 111, In-band IP Addresses

Chapter 8 Basic Setting

Table 12 Basic Setting > IP Setup (continued)

LABEL

DESCRIPTION

In-band IP Addresses

You can create up to 64 IP addresses, which are used to access and manage the Switch from the ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.

IP Address	Enter the IP address for managing the Switch by the members of the
	VLAN specified in the VID field below.
IP Subnet Mask	Enter the IP subnet mask in dotted decimal notation.
VID	Type the VLAN group identification number.
Default Gateway	Enter the IP address of the default outgoing gateway in dotted
	decimal notation.
Add	Click Add to insert the entry to the summary table below and save
	your changes to the Switch’s run-time memory. The Switch loses
	these changes if it is turned off or loses power, so use the Save link
	on the top navigation panel to save your changes to the non-volatile
	memory when you are done configuring.
Cancel	Click Cancel to reset the fields to your previous configuration.
Index	This field displays the index number of the rule. Click an index
	number to edit the rule.
IP Address	This field displays the IP address.
IP Subnet Mask	This field displays the subnet mask.
VID	This field displays the ID number of the VLAN group.
Default Gateway	This field displays the IP address of the default gateway.
Delete	Check the management IP addresses that you want to remove in the
	Delete column, then click the Delete button.
Cancel	Click Cancel to clear the selected checkboxes in the Delete column.

MGS3700-12C User’s Guide

111