ZyXEL Communications metrogigabit switch manual 410

Chapter 45 Configure Clone

The following table describes the labels in this screen.

Table 146 Management > Configure Clone

LABEL	DESCRIPTION
Source/	Enter the source port under the Source label. This port’s attributes are
Destination	copied.
Port	Enter the destination port or ports under the Destination label. These are
	the ports which are going to have the same attributes as the source port.
	You can enter individual ports separated by a comma or a range of ports by
	using a dash.
	Example:
	• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
	• 2-6indicates that ports 2 through 6 are the destination ports.
Basic	Select which port settings (you configured in the Basic Setting menus)
Setting	should be copied to the destination port(s).
Advanced	Select which port settings (you configured in the Advanced Application
Application	menus) should be copied to the destination ports.
Apply	Click Apply to save your changes to the Switch’s run-time memory. The
	Switch loses these changes if it is turned off or loses power, so use the
	Save link on the top navigation panel to save your changes to the non-
	volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

410

MGS3700-12C User’s Guide