Chapter 8 Basic Setting
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. You can check the firmware version number and monitor the Switch temperature, fan speeds and voltage in this screen.
Figure 42 Basic Setting > System Info
The following table describes the labels in this screen.
Table 8 Basic Setting > System Info
LABEL | DESCRIPTION |
System | This field displays the descriptive name of the Switch for identification |
Name | purposes. |
|
|
ZyNOS F/W | This field displays the version number of the Switch 's current firmware |
Version | including the date created. |
|
|
Ethernet | This field refers to the Ethernet MAC (Media Access Control) address of the |
Address | Switch. |
|
|
Hardware Monitor | |
|
|
Temperature | The Switch has temperature sensors that are capable of detecting and |
Unit | reporting if the temperature rises above the threshold. You may choose |
| the temperature unit (Centigrade or Fahrenheit) in this field. |
|
|
Temperature | BOARD, MAC and PHY refer to the location of the temperature sensors on |
| the Switch printed circuit board. |
|
|
Current | This shows the current temperature at this sensor. |
|
|
MAX | This field displays the maximum temperature measured at this sensor. |
|
|
MIN | This field displays the minimum temperature measured at this sensor. |
|
|
Threshold | This field displays the upper temperature limit at this sensor. |
|
|
Status | This field displays Normal for temperatures below the threshold and Error |
| for those above. |
|
|
80 |
| |
| ||
|
|
|