ZyXEL Communications MGS-3712, MGS-3712F 24.8 MVR Group Configuration

Chapter 24 Multicast

Table 63 Advanced Application > Multicast > Multicast Setting > MVR (continued)

LABEL	DESCRIPTION
*	Settings in this row apply to all ports.
	Use this row only if you want to make some settings the same for all
	ports. Use this row first to set the common settings and then make
	adjustments on a port-by-port basis.

	Note: Changes in this row are copied to all the ports as soon as you
	make them.

Source Port	Select this option to set this port as the MVR source port that sends and
	receives multicast traffic. All source ports must belong to a single
	multicast VLAN.

Receiver Port	Select this option to set this port as a receiver port that only receives
	multicast traffic.

None	Select this option to set the port not to participate in MVR. No MVR
	multicast traffic is sent or received on this port.

Tagging	Select this checkbox if you want the port to tag the VLAN ID in all
	outgoing frames transmitted.

Add	Click Add to save your changes to the Switch’s run-time memory. The
	Switch loses these changes if it is turned off or loses power, so use the
	Save link on the top navigation panel to save your changes to the non-
	volatile memory when you are done configuring.

Cancel	Click Cancel to begin configuring this screen afresh.

VLAN	This field displays the multicast VLAN ID.

Active	This field displays whether the multicast group is enabled or not.

Name	This field displays the descriptive name for this setting.

Mode	This field displays the MVR mode.

Source Port	This field displays the source port number(s).

Receiver Port	This field displays the receiver port number(s).

802.1p	This field displays the priority level.

Delete	To delete a multicast VLAN(s), select the rule(s) that you want to
	remove in the Delete column, then click the Delete button.

Cancel	Click Cancel to clear the Delete check boxes.

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this multicast group.

Configure MVR IP multicast group address(es) in the Group Configuration screen. Click Group Configuration in the MVR screen.