Chapter 13 Spanning Tree Protocol
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 72 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 26 Advanced Application > Spanning Tree Protocol > Configuration
LABEL | DESCRIPTION |
Spanning Tree | You can activate one of the STP modes on the Switch. |
Mode | Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or |
| |
| Multiple Spanning Tree. See Section 13.1 on page 125 for |
| background information on STP. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
132 |
| |
| ||
|
|
|