Chapter 3 Hardware Overview
3Pull the transceiver out of the slot.
Figure 12 Removing the Fiber Optic Cables
Figure 13 Opening the Transceiver’s Latch Example
Figure 14 Transceiver Removal Example
3.1.4Management Port
The MGMT (management) port is used for local management. Connect directly to this port using an Ethernet cable. You can configure the Switch via Telnet or the web configurator.
The default IP address of the management port is 192.168.0.1 with a subnet mask of 255.255.255.0.
3.1.5 Power Connector
Make sure you are using the correct power source as shown on the panel and that no objects obstruct the airflow of the fans.
Use the following procedures to connect the Switch to a power source after you have installed it.
Note: Check the power supply requirements in Chapter 42 on page 357, and make sure you are using an appropriate power source.
Keep the power supply switch and the Switch’s power switch in the OFF position until you come to the procedure for turning on the power.
38 |
| |
| ||
|
|
|