Chapter 24 Multicast
Note: A port can belong to more than one multicast VLAN. However, IP multicast group addresses in different multicast VLANs cannot overlap.
Figure 112 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
The following table describes the labels in this screen.
Table 64 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
LABEL | DESCRIPTION |
Multicast | Select a multicast VLAN ID (that you configured in the MVR screen) from |
VLAN ID | the |
|
|
Name | Enter a descriptive name for identification purposes. |
|
|
Start | Enter the starting IP multicast address of the multicast group in dotted |
Address | decimal notation. |
| Refer to Section 24.1.1 on page 205 for more information on IP multicast |
| addresses. |
|
|
End Address | Enter the ending IP multicast address of the multicast group in dotted |
| decimal notation. |
| Enter the same IP address as the Start Address field if you want to |
| configure only one IP address for a multicast group. |
| Refer to Section 24.1.1 on page 205 for more information on IP multicast |
| addresses. |
|
|
Add | Click Add to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
MVLAN | This field displays the multicast VLAN ID. |
|
|
Name | This field displays the descriptive name for this setting. |
|
|
Start | This field displays the starting IP address of the multicast group. |
Address |
|
|
|
218 |
| |
| ||
|
|
|