Chapter 31 Differentiated Services
31.3.1 Configuring 2-Rate 3 Color Marker Settings
Use this screen to configure TRTCM settings. Click the
Note: You cannot enable both TRTCM and Bandwidth Control at the same time.
Figure 154 IP Application > DiffServ >
The following table describes the labels in this screen.
Table 92 IP Application > DiffServ >
LABEL | DESCRIPTION |
Active | Select this to activate TRTCM (Two Rate Three Color Marker) on the Switch. |
| The Switch evaluates and marks the packets based on the TRTCM settings. |
| Note: You must also activate DiffServ on the Switch and the individual |
| ports for the Switch to drop red (high loss priority) colored packets. |
|
|
Mode | Select |
| uncolored. All incoming packets are evaluated against the CIR and PIR. |
| Select |
| Incoming packets are evaluated based on their existing color. Incoming |
| packets that are not marked proceed through the Switch. |
284 |
| |
| ||
|
|
|