ASSEMBLY
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
INSTALLING THE POWER HEAD TO THE ATTACHMENT
See Figure 3.
WARNING:
Never install, remove, or adjust any attachment while power head is running. Failure to stop the engine can cause serious personal injury.
The attachment connects to the power head by means of a coupler device.
Stop the engine and disconnect the spark plug wire.
Loosen the knob on the coupler of the power head shaft and remove the hanger cap from the attachment.
Push in the button located on the attachment shaft. Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.
Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
For removing or changing the attachment:
Stop the engine and disconnect the spark plug wire.
Loosen the knob.
Push in the button and twist the shafts to remove and separate ends.
ATTACHING THE STORAGE HANGER
See Figure 4.
There are two ways to hang your attachment for storage.
To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.
The secondary hole in the attachment shaft can be used for hanging purposes as well.
ATTACHING THE “J” HANDLE
See Figure 5.
A “J” handle must be used for ensuring the best control and maximizing operator safety when using a brushcutter.
Stop the engine and disconnect the spark plug wire.
Place the bottom
Insert the end of the
Push the bolt through the clamp and handle.
Install flat washer, lock washer, and wing nut to hold the assembly in place.
Adjust the position of the handle to the area indicated by the label on the drive shaft housing.
Tighten the wing nut securely.
ATTACHING THE BRUSHCUTTER GUARD
See Figure 6.
The guard is shipped installed on these brushcutter models. Instructions have been included for reference when changing from string trimmer operation back to brushcutter operation.
Stop the engine and disconnect the spark plug wire. With the string head removed, place the brushcutter guard on the gear head as shown.
Install the three hex head screws from bottom through the guard and into the gear head.
Tighten the screws securely and torque to
ATTACHING THE SHOULDER HARNESS
See Figure 7.
Connect the latch on the shoulder harness to the strap hanger.
Adjust the strap to a comfortable position.
CONVERTING FROM BRUSHCUTTER TO STRING TRIMMER
To convert from the brushcutter to the string trimmer, remove the blade and brushcutter guard, attach the straight shaft grass deflector and install the string head.
REMOVING THE TRI-ARC® BLADE AND BRUSHCUTTER GUARD
See Figures 8 - 9.
WARNING:
Always wear heavy gloves when removing or handling the blade. Contact with the sharp blade may result in cuts and/or other serious personal injuries.
7 — English