Porter-Cable 919.329150, D20498 owner manual Troubleshooting Guide, Problem Cause Correction

TROUBLESHOOTING GUIDE

PROBLEM		CAUSE		CORRECTION
Engine will not start	1.	Low on fuel or oil.	1.	Add fuel or oil.
	2.	Ignition switch in "Off" position.	2.	Turn to "ON" position
	3.	Faulty spark plug.	3.	Replace spark plug.
	4.	Choke in wrong position.	4.	Adjust choke accordingly.
	5.	Fuel shut-off valve in closed	5.	Open fuel shut-off valve.
		position.
	6.	Unit loaded during start-up.	6.	Remove load from unit.
	7.	Spark plug wire loose.	7.	Attach wire to spark plug.
No electrical output	1.	Faulty receptacle.	1.	Have Authorized Sears Service
				Center replace.
	2.	Circuit breaker kicked out.	2.	Depress and reset.
	3.	Defective capacitor.	3.	Have Authorized Sears Service
				Center replace capacitor.
	4.	Faulty power cord.	4.	Repair or replace cord.
	5.	GFCI receptacle circuit breaker	5.	Depress and reset.
		kicked out.
Repeated circuit breaker	1.	Overload	1.	Reduce load.
tripping	2.	Faulty cords or equipment.	2.	Check for damaged, bare, or
				frayed wires on equipment.
				Replace.
Generator overheating the	1.	Generator overloaded.	1.	Reduce load.
circuit breaker depressed	2.	Insufficient ventilation.	2.	Move to adequate supply of
				fresh air.

19 — ENG D20498 Rev. 0 6/9/00