RedMax SGCZ2401S-CA MA4 MA5 MA6, AIR Filter, Fuel Filter, Spark Plug, Tightening Torque, Muffler

Page 42

MA4

(1)

MA5

(1)

MA6

.025 in

0.655mm

English

9. Maintenance

■AIR FILTER

•The air filter, if clogged, will reduce the engine performance. Check and clean the filter element in warm, soapy water as required. Dry completely before installing. If the element is broken or shrunk, replace with a new one. (MA4)

(1) Air filter

■FUEL FILTER

•When the engine runs short of fuel supply, check the fuel cap and the fuel filter for blockage. (MA5)

(1) Fuel filter

■SPARK PLUG

•Starting failure and mis-firing are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a replacement plug, use the correct type specified by RedMax. (MA6)

•REPLACEMENT PLUG IS A NGK CMR7H.

IMPORTANT

•Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.

•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.

TIGHTENING TORQUE:

87–104 (in-lbs) (9.8–11.8 N.m.)

■MUFFLER

WARNING

•Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

•Note that failing to do so may result in the

42

Image 42

Contents SGCZ2401S SGCZ2401S-CA Contents Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOI Tables des matieres ContenidoAdvertencias Contenidas EN EL Manual Specifications Parts locationSGCZ2401S/SGCZ2401S-CA Emplacement des pieces Situación de las piezas Fiche techniqueEspecificaciohes Machine Wear head, eye and ear protectionImportante Emission Control Symbols on the machinePosition SGCZ2401SEmplacement PosiciónControl DE Emisiones For safe operation Working ConditionWorking Circumstance Condiciones DE Trabajo Consignes de securite Instrucciones de seguridadConditions DE Travail PrecaucionesWorking Plan Before Starting the EngineDE LA Machine Plan DE TravailPlan DE Trabajo Avant DE Mettre LE Moteur EN MarcheUsing the Product Starting the EngineDemarrage DU Moteur Arranque DEL MotorUtilisation DE LA Machine USO DEL Producto Maintenance If Someone ComesSI Alguien SE Aproxima SI QUELQU’UN S’APPROCHEEntretien MantenimientoHandling Fuel Refill after cooling the engineTransportation Manipulación DEL Combustible Manipulation DU CarburantTransport Llenar una vez que el motor se haya enfriadoSet up Assemblage Montaje Cuttercase Locking holes SE4 SE5 SE6Cuttercase SE4 Blade GuardCouvert de lame Trous de verrouillage Assemblage MontajePORTE-LAME SE4 Cabezal DE Corte SE4 Bastidor del cortador cuter Orificios de bloqueoWhen using RedMax/ZENOAH genuine oil FuelRecommended Mixing Ratio Gasoline 50OIL Lors de l’utilisation de la véritable huile RedMax/ZENOAH Rapport DE Melange Recommande Essence 50 HuileCarburant Combustible Proporción DE LA Mezcla Recomendada Gasolina 50 AceiteHOW to MIX Fuel Fueling the UnitFor Your Engine LIFE, Avoid Eviter Pour Prolonger LA Duree DE VIE DU Moteur Comment Obtenir UN BON Melange Como Mezclar EL CombustibleRemplissage DU Reservoir Abastecimiento DE LA UnidadFuel Combustible SIN Aceite Gasolina Cruda Operation OP1 OP2 OP3 OP4 Starting EngineCutting head will start rotating upon the engine starts Fonctionnement Uso Palanca del estrangulador 2 cerrarOP5 Adjusting Throttle CableAdjusting Idling Speed OP6 OP6 Stopping Engine OP3Reglage DU Ralenti OP6 Reglage Câble D’ACCÉLÉRATEURAjuste Cable DEL Acelerador UtilisationHOW to USE OP7Forma DE UTILIZAClÓN OP9 OP8Cutting Work Recommended ApplicationsApplications Recommandées Aplicaciones RecomendadasMaintenance Maintenance ChartTableau D’ENTRETIEN EntretienMantenimiento Tabla DE MantenimientoBlade To install bladesMA1 MA2 MA3 To Sharpen bladeEntretien Mantenimiento LameCuchilla AIR Filter Replacement Plug is a NGK CMR7HMA4 MA5 MA6 Fuel FilterBougie D’ALLUMAGE Filtre a CarburantFiltro DE Combustible Couple DE SerrageGearcase and Cuttercase MA8 MA7 MA8Spark Arrester MA7 Intake AIR Cooling VentOuïe DU Refroidissement PAR AIR PARE-ETINCELLES MA7 Parachispas MA7LE Couvert DE Courroie ET DE Lame MA8 Bastidor DE Engranajes Y Bastidor DEL Cortador MA8Disposal Procedures to be Performed After Every 100 Hours of USEStorage MA9Mise au rebut Eliminación Procedure a Effectuer Toutes LES Heures D’UTILISATIONRangement Almacenamiento Procedimientos a Realizar Cada 100 Horas DE USOTroubleshooting guide 12. Guía de localización y solución de problemasGuide de localisation des pannes Reciprocators NotaParts list SGCZ2401S/SGCZ2401S-CA SGCZ2401S/SGCZ2401S-CA Engine Unit S/N 60100101 and up Part Number Description Qty Manufacturer’s warranty coverage Owner’s warranty responsibilitiesCouverture de la garantie constructeur Obligations du propriétaire liées à la garantieCobertura de la garantía dada por el fabricante Responsabilidades del propietarioLimited Warranty Garantie limitée Garantía Limitada Zenoah AMERICA, INC