Dolmar MS-22C instruction manual Mounting of Protector

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used.

Be sure to use genuine DOLMAR nylon cutting head. Nylon cutting head Protector for cord cutter

–If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately.

CAUTION: The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regula- tions.

Operation of the equipment without the guard being in place is not permitted.

–Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).

–When using the string head, fit the protector (6) into the protector (1), and tighten them with two nuts (5) and two screws (4).

9