Note: – If the starter knob is pulled repeatedly when the choke button remains at “ 
” position, the engine will not start easily due to excessive fuel intake.
–In case of excessive fuel intake, remove the spark plug and pull the starter knob slowly to remove excess fuel. Also, dry the electrode section of the spark plug.
Caution during operation:
If the control lever is opened fully in a
Starting the warm engine
–As described above, except without moving the choke button.
Stopping
–Release the throttle lever (6) fully, and when the engine rpm has lowered, push the
–Be aware that the cutting head may not stop immediately and allow it to slow down fully.
IDLE ADJUSTMENT
The nylon cutting head should not run when the control lever is fully released. If necessary, adjust the idle rpm using the idle adjusting screw.
Checking the Idling speed | (1) |
–Idle speed should be set to 3,000 / min.
If necessary correct it by means of the idle screw (the nylon cutting head must not turn when the engine is on idle).
Screwing in the screw (1) will cause an increase in the engine speed, whereas backing off the screw will reduce the engine speed.
Slow High
NYLON CUTTING HEAD
The nylon cutting head is a dual string trimmer head capable of bump & feed mechanisms.
The nylon cutting head will automatically feed out the proper length of nylon cord by the changes in centrifugal force caused by increasing or decreasing RPMS. However, to cut soft grass more efficiently, bump the nylon cutting head against the ground to feed out extra cord as indicated under operation section.
Most effective cutting area
Operation
–Increase the nylon cutting head speed to approx. 6,000 / min.
Low speed (under 4,800 / min) is not suitable, the nylon cord will not feed out properly at low speed.
–The most effective cutting area is shown by the shaded area.
13