ASSEMBLY
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose Trigger Handle
Spray Wand
M8 10 mm Bolt
M8 13 mm Flange Nut
Hitch pins (2) Wheels (2) Handle Operator’s Manual
TOOLS NEEDED
13 mm Socket (9/16 in.)
10 mm Wrench (7/16 in.)
WARNING:
If any parts are damaged or missing do not operate this tool until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
attaching the wheel assembly
See Figure 2.
nLocate the axle, hitch pins, washers, and wheels.
nSlide the axle through the hole in the center of the wheel.
nSlide the washer onto the axle.
nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.
nPush the hitch pin into the hole on the end of the axle to secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.
nRepeat with the second wheel.
INSTALLing the handle
See Figure 3.
nPush and hold the
NOTE: Before use, pull the handle up until the lock button snaps through the locking slots to secure the handle in place.
INSTALLing the UPPER AND LOWER SPRAY WAND HOLDER
See Figure 4.
nPlace upper spray wand holder over the holes.
nAlign the lower bolt with the holes and push the bolt through.
nPlace the lock nut over the lower bolt and tighten se- curely.
nPlace lower spray wand holder over the holes.
nAlign the bolt with the holes and push the bolt through.
nHold flange nut with 13 mm wrench and bolt head with 10 mm socket. Tighten until the bolt is snug.
assembling the trigger handle
See Figure 5.
To attach the spray wand:
nPlace the threaded end of the spray wand in the connector on the end of the trigger handle.
nTurn the connector clockwise until it stops. This secures the spray wand in place.
connecting high pressure hose to
TRIGGER HANDLE
See Figure 6.
nScrew the collar on the high pressure hose into the trigger handle inlet coupler by turning the hose collar clockwise.
nPull on the hose to be certain it is properly secured.
attaching INJECTION hose
See Figure 7.
Before detergent can be used with this machine, the injection hose must be attached.
nPush the injection hose filter onto the end of the injection hose (if not already installed).
nPush the open end of the clear injection hose securely over the fitting.
NOTE: Keep injection hose away from hot surfaces.
Page 8 — English