Briggs & Stratton 30000 SERIES Never operate generator without protective housing or covers

Page 6

warning

Contact with muffler area can result in serious burns.

Exhaust heat/gases can ignite combustibles or structures causing a fire.

DO NOT touch hot parts and AVOID hot exhaust gases.

Allow equipment to cool before touching.

DO NOT install the generator closer than 5 feet (1.5m) from any combustibles or structures with combustible walls having a fire resistance rating of less than 1 hour.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

warning

Starter and other rotating parts can entangle hands, hair, clothing, or accessories.

NEVER operate generator without protective housing or covers.

DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.

Tie up long hair and remove jewelry.

caution

Excessively high operating speeds increase risk of injury and damage to generator.

Excessively low speeds impose a heavy load.

DO NOT tamper with governed speed. Generator supplies correct rated frequency and voltage when running at governed speed.

DO NOT modify generator in any way.

notice

Exceeding generators wattage/amperage capacity can damage generator and/or electrical devices connected to it.

See Essential Circuits in Operator’s manual.

Start generator and let engine stabilize before connecting electrical loads.

notice

Improper treatment of generator can damage it and shorten its life.

Use generator only for intended uses.

If you have questions about intended use, ask dealer or contact Briggs and Stratton.

Operate generator only on level surfaces.

Adequate, unobstructed flow of cooling and ventilating air is critical to correct generator operation.

The Coolant Fill, Battery and Control Panel doors must be installed whenever the unit is running.

DO NOT expose generator to excessive moisture, dust, dirt, or corrosive vapors.

Despite the safe design of the home generator, operating this equipment imprudently, neglecting its maintenance or being careless can cause possible injury or death.

DO NOT start engine with air cleaner or air cleaner cover removed.

DO NOT insert any objects through cooling slots.

DO NOT use the generator or any of its parts as a step. Stepping on the unit can cause stress and break parts. This may result in dangerous operating conditions from leaking exhaust gases, fuel leakage, oil leakage, etc.

If connected devices overheat, turn them off and disconnect them from generator.

Shut off generator if:

-electrical output is lost;

-equipment sparks, smokes, or emits flames; -unit vibrates excessively.

BRIGGSandSTRATTON.COM

Image 6
Contents Series Liquid-Cooled Home Generator System Engine Where to Find UsDate of Purchase Generator Model Number Model Revision Serial NumberTable of Contents Safety Rules Hazard Symbols and MeaningsBRIGGSandSTRATTON.COM Page Never operate generator without protective housing or covers Installation Home Generator Location Generator LocationGeneral Location Guidelines Concrete Slab Electrical and Fuel Inlet LocationsLifting the Generator Female NPTTo Close an Access Door Access DoorsTo Open an Access Door Gaseous Fuel SystemNo leakage is permitted Fuel Consumption Natural Gas LP VaporLP Vapor Natural System Connectors Pole Connector Plug+12 Volt DC, .5 Amp Output Internal auxiliary power supply Generator AC Connection System Fault Detection SystemTo install the remote LED indicator Grounding the GeneratorFinal Installation Considerations System Control PanelInitial Start-up No Load BatteryFuel Supply System Fuel ConversionVoltage Phi Lamda Schematic/ Wiring Diagram Controls Setting Exercise TimerInstallation Inspection OperationBRIGGSandSTRATTON.COM Manual de Instalación y Arranque Motor Dónde encontrarnosFecha de compra Generador Número de Modelo Revisión Número de SerieInstrucciones importantes de seguridad Instalación Mandos UtilizaciónConserve estas instrucciones Símbolos de Peligro y SignificadosTensión peligrosa Ate para arriba el pelo largo y quite la joyeríaPrecaución No modifique al generador en ninguna formaInstalación Ubicación del Sistema de Generador de Doméstico Ubicación del GeneradorPautas Generales para la Ubicación del Generador Solera de concreto Ubicación de las entradas eléctricas y de combustibleElevación del Generador Puertas de Acceso Para abrir una puerta de accesoPara cerrar una puerta de acceso Sistema de combustible gaseoso No encienda un cigarrillo o fumeGas Natural Vapor de PL Dimensiones de la Cañería de CombustibleConsumo de Combustible Vapor de GasConexiones de Sistema Cableado para toma de 10 polosInterconexiones del Circuito de Control Sistema de Conexión de c.a. del GeneradorConexión a Tierra del Generador Sistema de Detección de FallasPanel de Control del Sistema Consideraciones finales para la instalaciónBatería Sistema de Suministro de CombustibleArranque inicial sin carga Nota no utilice una batería de ciclo profundoConversión de combustible Tensión Phi LamdaMandos UtilizaciónSecuencia de operación automática Configuración del temporizador de práctica Inspección posterior a la instalaciónTemporizador de enfriamiento del motor BRIGGSandSTRATTON.COM Manuel d’Installation et Démarrage Moteur Où nous trouverDate d’achat Génératrice Numéro de modèle Révision Numéro de sérieDirectives de sécurité importantes Installation Commandes FonctionnementSymboles de Danger et Moyens Directives de sécurité importantesSécurité Tension dangereuse Avis Responsabilités de l’Acheteur Responsabilités de l’InstallateurDescription de l’équipement Précautions Lors du DéballageInstallez l’unité à l’extérieur Seulement Emplacement du Génératrice d’état d’AttenteDirectives Générales Concernant l’Emplacement Dégagement Autour de la GénératriceDalle de béton Soulèvement de la GénératricePour ouvrir une porte d’accès Instalación CommandesPortes d’Accès Pour fermer une porte d’accèsLe système de combustible gazeux Aucune fuite ne peut être toléréePropane Gaz Consommation de CombustibleGas Naturel Vapeur PL Grosseur du Tuyau de CombustibleConnexions de système Entretien Dépannage GarantieMise à la Masse de la Génératrice Interconnexions du Circuit de CommandeSécurité Instalación Commandes Système de Détection des PannesInterrupteur de système Tableau de Commande du SystèmeConsidérations pour l’installation finale Huile à Moteur Fusible de 15 AmpèresSystème d’Alimentation en Combustible Système de refroidissementBatterie Démarrage initial sans chargeTout en observant l’afficheur de l’analyseur d’oxygène Conversion du combustibleTension LamdaFonctionnement CommandesCapteur de Prise en Charge de la Tension de Service Séquence de fonctionnement automatiqueVérification installation Réglage de la minuterie de cycle d’exerciceThis page reserved