INSTALLATION
BEFORE INITIAL START-UP
Engine Oil
This engine is shipped from the factory filled with the recommended oil. Before starting the engine, check oil level and ensure that engine is serviced as described in the engine operator’s manual.
CAUTION
Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure.
•Refer to engine manual for oil fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
Oil Considerations
Your Home Generator System is equipped with an engine that has been
The system is filled with synthetic oil (API SJ/CF
NOTE: The use of synthetic oil DOES NOT alter the required oil change intervals described in the engine operator’s manual.
Battery Connection
The Home Generator System is supplied with a 12 Volt DC 55
CAUTION
Installing the 15A fuse could cause the engine to start.
•DO NOT install the 15 Amp fuse until all plumbing and wiring has been completed and inspected.
NOTE: With the battery installed, all wiring to transfer switch and Home Generator System completed, utility power supplied to the Automatic Transfer Switch, and the unit in AUTO mode, the battery receives a trickle charge while the engine is not running.The trickle charger cannot be used to recharge a battery that is completely discharged.
Gaseous Fuel System
•Ensure that all fuel connections are tight, secure and without leaks.
•Ensure that all shutoff valves are OPEN and that adequate pressure is available (see installation manual).
WARNING
Propane and Natural Gas is extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
•DO NOT operate engine if smell of fuel is present or other explosive conditions exist.
•If you smell ‘raw’ gaseous fuel (natural or LP) near the unit, immediately turn off the gas supply to the Home Generator System.
•Contact your gas utility or the system installer for assistance in determining the source of the smell.
12