Baldor TS80, BALDOR GENERATORS, TS25, TS45, TS175, TS130 manual

Page 15

E.VOLTAGE ADJUST – The rheostat allows the user to “fine tune” the generator set’s voltage output. It is normally used to adjust output voltage after switching the output of the generator set to a different voltage.

F.METERS – These meters monitor and display the current operating parameters of the generator set. The Voltmeter monitors and displays the current operating AC output of the generator set.

The Hertz Meter monitors and displays the current operating frequency of the generator set.

The ammeter monitors and displays the amount of current that is being delivered by the generator set. This meter works in conjunction with the Voltmeter Switch (Item G) in determining which output leg to monitor.

G.AMMETER SWITCH – The switch allows the user to switch between L1, L2 and L3 to monitor the current in each output leg of the generator.

H.PANEL LIGHT – By turning on the panel light switch, the panel lights (Not pictured on diagram) will be energized and will illuminate the control panel.

I – SYSTEM FAULT INDICATORS – These lights will come on when a fault condition or a warning condition develops.

The “Low Oil Pressure” light will come on when the engine’s oil pressure drops below 15 PSI. This condition will trigger a fault shut–down and the unit will stop.

The “Over–crank” light will come on when the engine has failed to start after four attempted crank cycles. Each crank cycle consists of a 12 second time period followed by a 12 second rest time period.

The “Over–speed” light will come on when the engine’s operating speed rises above it’s normal operating parameters. This condition will trigger a fault shut–down and the engine will stop.

High Temperature light will come on when the engine’s operating temperature exceeds the safety set–point.

12

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Baldor Generators OPERATOR’S Manual TowablesPage Safety Warnings FORM# S-PSG-001-3 ```` for Gasoline or Diesel Powered Generator Sets ```` Page Forward \ISO9001\FORMS\SCSD0037.MSW Features & Specifications Page Switchable Connection Information Control Panel Operation Function Page Page Operation PRE-START Procedure Operation Starting Operation Cranking Control LOW Voltage Troubleshooting GeneratorFluctuating Voltage High VoltageOverheating Mechanical Noise Generator Frame Produces Shock When TouchedTroubleshooting Engine Page Magnaplus Generator Table of Contents Specifications Parts List Single Bearing Storage SafetyReceiving and Storage Unpacking and HandlingPMG optional Principles of OperationPreparation for USE InstallationParallel Operation Nonlinear LoadingEND Play Testing Generator MountingTorsional Vibration Environmental Considerations Wiring ConnectionsLOW WYE Connection Double Delta -- Single Phase Connection Operation PRE-START InspectionSTART-UP Shutdown Procedure MaintenanceDrying Windings TestingField Flashing ServiceDiode Testing GeneralBearing Removal Bearing ReplacementReturned Goods TroubleshootingGenerator Produces LOW VOLTAGE, no Load Generator Produces no VoltageGenerator Produces LOW Voltage When Load Applied Generator Produces Fluctuating VoltageGenerator Produces High Voltage Generator Produces Mechanical Noise Generator is OverheatingSpecifications Parts List Single Bearing Parts List Dual Bearing Towing Vehicle Rules for Safe Trailer OperationTowing Heavy Trailer Loads Electrical Trailer WiringSafety Checks Trailer Light Mounting and Connection Trailer Light KIT Wiring InstructionsLimited Warranty Owner’s Responsibilities Page California Proposition 65 Warning
Related manuals
Manual 88 pages 1.48 Kb
Top Page Image Contents