Baldor TS45, TS25 Three/Single Phase Operation, Receptacle Panel Load Connections, see Figure

Table 4-2 Three/Single Phase Operation

	Alternator	Voltage			Voltage at Terminal Lugs					Voltage at Plug Receptacles
Switch			Line To Line Voltage				Line To Neutral Voltage			120VAC	240VAC Receptacles
	Winding	Adjust
Position										Receptacles	(Twist Lock)
	Connection	Position
			L1−L2	L2−L3		L1−L3	L1−N	L2−N	L3−N	L−N	L−L	L−N
	Series High	Minimum	416	416		416	240	240	240	120	208	120
480/277		Middle	460	460		460	266	266	266	133	230	133
	Wye
		Maximum	480	480		480	277	277	277	139	240	139
	Parallel Low	Minimum	208	208		208	120	120	120	120	208	120
208/120		Middle	230	230		230	133	133	133	133	230	133
	Wye
		Maximum	240	240		240	139	139	139	139	240	139
	Parallel Low	Minimum				200	100		100	100	200	100
240/120		Middle				220	110		110	110	220	110
	ZigZag
		Maximum				240	120		120	120	240	120

No connection at Terminal Lug #2.

Receptacle Panel Load Connections, see Figure 4-4.

1.240/120VAC voltage is present at the receptacle panel at all times when generator is running.

2.Carefully inspect all Individual load cables for broken insulation or other signs of damage. Never use a damaged cable. Replace it before usage.

3.Individual load cables may be routed into the receptacle compartment through the Enclosure Electrical Access Panel.

4.Individual load cables may be connected or disconnected while generator is running. Use extreme care not to touch any electrical wire or terminal to avoid shock hazard.

5.Keep Enclosure Electrical Access Panel closed at all times. This prevents rain or other harmful elements from entering the compartment. Output metering and gauges can be observed through the window in the Enclosure Electrical Access Panel.

Figure 4-4 Receptacle Panel (Single Phase)

Circuit Breakers (Single or Double pole)

Circuit Breakers provides protection on some units. To reset a breaker, place it in the OFF then the ON position.

Note:

Single phase power is always available.

		(GOLD)	(GOLD)
		Y	X
		X
		CS6369
		125/250V
Reset	Test	Y 50A	W
			G
		W
	CS6365N	(SILVER)
GFI Outlet		240V, 50A
120V, 20A

Meters, switches, lights and other operator control components are located in various places on each panel. Figure 4-5can be used to identify the function and features of each operator control regardless of where it is located on your panel.

4-6 Operation MN2417