Connecting to Video Equipment
(such as a Laser Disc player, a DVD player, a DSS,or a Video Camera)
■ Read SAFETY GUIDELINES ( | to | )I carefullyVIIto ensure maximum safety |
before proceeding to these steps: |
|
|
1)Choose an appropriate site and install the product on a level table where the stand is secure.
•Install the monitor to have ready access to a power socket available.
2)Make sure that the video equipment’s power switch is off.
3)Interconnect the signal input terminal on the monitor rear panel and the video equipment’s signal output terminal to each other using an commercially available video cable.
4)Insert one end of the power cable included into the
5)Turn on the monitor, then the video equipment’s to make sure that a display image
appears on the monitor screen.
• For instructions on turning on the monitor and adjusting its display images, see
“Operating Instructions” ( | to 9 | ).19 |
ENGLISH
Speaker (R)
Power cable connector
Monitor rear panel
Speaker (L)
Video equipment
(such as a video disc player, a DVD player, and a video camera)
External Monitor
VIDEO 1 |
|
COMPOSITE S |
|
IN OUT | IN |
Power |
|
|
|
|
| VIDEO 2 |
| VIDEO 1 |
|
| Red(R) To Svideooutput terminals | White(L) | Yellow(V) | Tocomponent outputterminals | |
cable | AUDIO IN | AUDIO IN | P | COMPONENT |
| COMPOSITE S |
|
|
|
|
|
| |||
R /CR P B /CB | Y | IN | OUT |
| IN |
|
|
|
| ||||||
R | L/MONO | R | L/MONO |
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||
| Red(R) | White(L) | Red(R) | White(L) |
|
|
| Yellow(V) |
| To component output terminals | To S video input terminals | video |
| Toaudio/video outputterminals |
|
|
|
|
|
|
|
|
|
|
|
|
| Use if the |
|
|
|
| terminals | Toaudio |
|
|
|
|
|
|
|
|
| equipment |
|
|
|
|
|
|
|
|
|
|
|
|
| has an |
|
|
| ||
|
|
|
| To audio/ |
| To component |
|
|
|
| S video |
|
|
| |
|
| input |
| video input |
| input terminals |
|
|
| input terminal |
|
|
| ||
|
|
| terminals |
|
|
|
|
|
|
|
|
|
|
|
Red(R) | White(L) | terminals | To component |
input terminals | |||
Toaudiooutput |
•If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality. (If an S video input terminal and a video input terminal connect to the monitor at the same time, S video input would govern.)
• If video equipment is equipped with component video output (Y, P | B, P R or Y, C B, C R ), please | |
connect to the corresponding color (Y, P | B, P | R ) input jack on the component input of the |
monitor. |
|
|
•If the VIDEO1 OUT terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the main unit. If an external monitor is not being used, the cable must be removed from the VIDEO OUT terminal. The image will appear
white as saturation level is reached.
NOTE : Y to Y, P B
7