Making connections
Installing the IEEE-1394 card in the host computer
Installing the Kodak Driver software
Installing the FireWire cable
Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak driver software before you plug the scanner into the host computer.
IMPORTANT:You must install the software on the host computer before you connect the scanner.
Install the IEEE-1394 (FireWire) card according to the directions supplied with the IEEE-1394 card.
IMPORTANT: Use proper precautions to avoid static when you install the IEEE-1394 card in your computer. Make sure the computer power cord is disconnected.
1.Insert the installation CD in the CD-ROM drive. The installation program starts automatically.
2.Follow the on-screen instructions to install the TWAIN Datasource, ISIS Driver and the Kodak Scan Validation Tool.
3.Shut down the host computer.
An IEEE-1394 six-pin connector is provided on the rear panel of the scanner for IEEE-1394 connectivity.
1. Plug the end of the cable with the right angle into the scanner.
2.Connect the other end of the cable into the IEEE-1394 card outlet in the host computer. Be sure that it is installed correctly and properly seated.
CAUTION: DO NOT FORCE THE CONNECTOR. If the cable is not properly connected, it could cause damage to the scanner.
