Kodak 6J7611A manual 61500 May

Page 66

Messages	ID#	Operator Message
UDDS calibration failed	333	The UDDS calibration failed.
		• Be sure you are using the correct ultrasonics calibration target.
		See Chapter 3, “Calibrating the scanner”.
		• Clean the sensors and try again.
		• If the problem persists, call Service.
UDDS calibration succeeded	332	Informational message. The scanner ultrasonics has been
		successfully calibrated.

UDDS is not calibrated	21	• Perform an Ultrasonics calibration. See Chapter 3, “Calibrating
		the scanner” for procedures.

UDDS multi-feed detected	23, 24, 334	A multi-feed document condition has been detected.
		• Check the host monitor to see if there are any overlapped
		documents that may need to be rescanned.
		This condition may be caused by:
		• Poor document separation causing overlapped documents.
		• Stickers on the documents.
		• Wrinkles in the documents
		• Thick documents with high multi-feed settings.

Unable to scan	5	• The previous error condition has not been corrected. For
		example, there could be a document jam that has not been
		completely cleared.
		• Incomplete or conflicting image processing parameters.
		• See other log entries for the actual condition.

6-10	A-61500 May 2010

Image 66

Contents I600/i700 Series Scanners Contents Appendix a Introduction Scanner models New features Scanner features Speed/capacity Throughput Safety information MsdsGas springs warning User precautionsEMC statements United StatesPower system Acoustic emissionConnection Getting Started For i700 Series Scanners only Microsoft Windows 7 64-bitMaking connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Using the Scanner Turning the scanner on and offStarting and stopping scanning Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Page Forward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeCalibrating the scanner Image calibration Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeAccessing the Enhanced Printer Changing the printer position Replacing the ink cartridge Page Replacing the blotter strips Replacing the ink cartridge carrier Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover 61500 May Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the imaging Replacing the preSeparation pad GuidesTroubleshooting Indicator lightsLed display Description Accessing the Operator Log Page Page I600 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May I600 Series Scanners Numerical MessageListing 61500 May I700 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May I700 Series Scanners 61500 May Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/SpeedKodak, 2010. All rights reserved. TM Kodak