Kodak 6J7611A manual Informational message. The pod was closed

Messages	ID#	Operator Message
Paused waiting for host	1, 48	The feeder has stopped and the transport is still running
		because the scanner’s internal image buffer is almost full.
		Processing will automatically resume after the capture software
		application has successfully retrieved enough images to allow
		the scanner to continue.
		• Be sure your host computer meets the recommended
		specifications to avoid this condition.
Please update firmware before	91	The expected production version of operational firmware was
scanning		not found. The back-up firmware is in use.
		• Reload the most recent version of operational scanner
		firmware.
Pod door closed	26	Informational message. The pod was closed.
Pod door opened	25	Informational message. The pod is not closed completely.
Power on self-test completed	20	Informational message. The scanner has completed its self-tests
		after power-on.
Power on self-test failed	6	This error could occur during scanner power-up.
		• Power-down the scanner, then power down the PC. Wait a few
		seconds and then power the PC back up, then power up the
		scanner.
		• If the problem persists, call Service.
Printer bitmap font in use	281	Informational message. An alternate printer font file was found
		and is being used instead of the default font.
Rear calibration failed	112	The rear imaging path calibration failed.
		• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.
		• Try to calibrate the scanner again. Be sure you are using the
		correct calibration target. See Chapter 3, “Calibrating the
		Scanner”.
		• If the problem persists, call Service.
Rear calibration succeeded	113	Informational message. The rear image path has been
		successfully calibrated.
Refeed document set	Many ID	Documents passed through the transport but no images were
	numbers	created.
		• Clean document sensors.
		• Make sure the leading edges of the documents are aligned.
		See Chapter 3, “Document preparation” for more information.
		• Check the condition of your feed module and separation roller
		tires and your pre-separation pad. Clean and replace if
		necessary.
		• Refeed these documents and verify that the images have been
		captured.
Requested pages scanned	337	Informational message. The scanner has completed scanning
		the requested number of documents.
Paused for image processing	63	Informational message. Scanner paused.
		• Slow host PC may not be able to keep up with the scanner.
Transport timeout	336	Informational message. The transport was turned off due to
		inactivity.

A-61500 May 2010 6-9