5 Maintenance
This chapter provides:
•a cleaning frequency chart
•a list of cleaning tools and materials
•a list of supplies and accessories
•cleaning procedures for the scanner
•replacement procedures for parts that are
IMPORTANT: Scanner components marked with a green tab indicate
Cleaning your scanner and preventative maintenance on a regular basis is required to ensure the best possible image quality. The following is a preventative maintenance procedure that is recommended to prevent costly interruptions during production scanning. Following this procedure as recommended should take approximately 5 to 10 minutes.
Some document types generate more paper dust and debris and may require more frequent cleaning than recommended.
NOTES:
•Follow the recommended Kodak cleaning procedures. Do not use air, liquid or gas spray cleaners. These cleaners only displace the dust, dirt or debris to another location within the scanner, which could cause the scanner to malfunction.
•Some debris from the rubber tires on the feed module and separation roller is normal. Tire debris does not always mean that the tires are worn or damaged. After cleaning, inspect the tires for wear and replace the separation roller or feed module if necessary.
•When cleaning rollers/tires, allow the rollers/tires to dry completely before scanning.
•Use only approved cleaning materials as specified in this manual.