Kodak 6J7611A manual Stop/Pause and Start/Resume buttons

Page 14

7 Stop/Pause and Start/Resume buttons —

Stop/Pause (white with red triangle) button: press once to temporarily pause scanning (the green button can then use used to resume scanning). Press twice to stop scanning (end of job).

Start/Resume (green) button: to start scanning.

8LEDs— illuminate or flash from top to bottom as follows:

Illuminates when the power is turned on and the scanner is idle. This indicator will flash if the scanner is in “sleep” or lamp saver mode.

illuminates when the scanner is enabled and/or scanning, and flashes when the scanner is powering up.

flashes when a document has jammed in the transport or when a multi-feed has been detected. Illuminates when a user- correctable error has been detected.

Illuminates when you need to call Service.

Refer to Chapter 6, Troubleshooting, for complete descriptions of the LED indicators.

9Power switch — press the power switch on (I) or off (O) as required.

10Exit deflector (optional) — aids in document stacking.

11Paper Present Sensor — detects the presence of documents in the elevator tray.

12* Height Adjustment Wire — located underneath the output tray (not shown in photo), this wire can be pulled out to raise the front of the output tray.

2-4	A-61500 May 2010

Image 14

Contents I600/i700 Series Scanners Contents Appendix a Introduction Scanner models New features Scanner features Speed/capacity Throughput Safety information MsdsGas springs warning User precautionsEMC statements United StatesConnection Power systemAcoustic emission Getting Started For i700 Series Scanners only Microsoft Windows 7 64-bitMaking connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Starting and stopping scanning Using the ScannerTurning the scanner on and off Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Page Forward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeCalibrating the scanner Image calibration Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeAccessing the Enhanced Printer Changing the printer position Replacing the ink cartridge Page Replacing the blotter strips Replacing the ink cartridge carrier Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover 61500 May Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the imaging Replacing the preSeparation pad GuidesTroubleshooting Indicator lightsLed display Description Accessing the Operator Log Page Page I600 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May Listing I600 Series ScannersNumerical Message 61500 May I700 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May I700 Series Scanners 61500 May Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/SpeedKodak, 2010. All rights reserved. TM Kodak