Kodak 6J7611A manual 61500 May

Page 73

Messages	ID#	Operator Message
UDDS calibration failed	333	The UDDS calibration failed.
		• Be sure you are using the correct ultrasonics calibration target.
		See Chapter 3, “Calibrating the scanner”.
		• Clean the sensors and try again.
		• If the problem persists, call Service.
UDDS calibration succeeded	332	Informational message. The scanner ultrasonics has been
		successfully calibrated.

UDDS is not calibrated	21	• Perform an Ultrasonics calibration. See Chapter 3, “Calibrating
		the scanner” for procedures.

UDDS multi-feed detected	23, 24, 334	A multi-feed document condition has been detected.
		• Check the host monitor to see if there are any overlapped
		documents that may need to be rescanned.
		This condition may be caused by:
		• Poor document separation causing overlapped documents.
		• Stickers on the documents.
		• Wrinkles in the documents
		• Thick documents with high multi-feed settings.

Unable to scan	5	• The previous error condition has not been corrected. For
		example, there could be a document jam that has not been
		completely cleared.
		• Incomplete or conflicting image processing parameters.
		• See other log entries for the actual condition.

A-61500 May 2010

6-17

Image 73

Contents I600/i700 Series Scanners Contents Appendix a Introduction Scanner models New features Scanner features Speed/capacity Throughput Msds Safety informationEMC statements User precautionsGas springs warning United StatesAcoustic emission Power systemConnection For i700 Series Scanners only Microsoft Windows 7 64-bit Getting StartedMaking connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Turning the scanner on and off Using the ScannerStarting and stopping scanning Manually ending scanning Automatically pausing and resuming the scannerMaterials Document preparationAdjusting the side guides and end stop Page Forward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Press Start/Resume Continuous feeding Manual feedingCalibrating the scanner Image calibration Page Click Calibrate Page Overview Enhanced PrinterFont size Printer specificationsAccessing the Enhanced Printer Changing the printer position Replacing the ink cartridge Page Replacing the blotter strips Replacing the ink cartridge carrier Page Maintenance Cleaning frequency chart Cleaning tools and materials Ordering parts Supplies and accessoriesOpening the pod Cleaning the output tray and elevator areaCleaning the separation roller tires Cleaning the drive rollersCleaning the feed module tires Close the printer access cover 61500 May Cleaning the scanner transport area Cleaning the imaging guides Cleaning the background stripsPage Running a transport cleaning sheet Replacing the feed module or feed module tires Replacement proceduresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Separation pad Replacing the preReplacing the imaging GuidesIndicator lights TroubleshootingLed display Description Accessing the Operator Log Page Page I600 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May Numerical Message I600 Series ScannersListing 61500 May I700 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May I700 Series Scanners 61500 May Problem Possible Solution Problem solvingMaintenance Appendix a Accessories Scanner Type/Speed Appendix B SpecificationsKodak, 2010. All rights reserved. TM Kodak