Kodak 6J7611A manual Image calibration

Page 28

Image calibration	Use the calibration target provided with your scanner. Be sure to use a
	good, clean calibration target. Additional calibration targets can be
	ordered. See Chapter 5, “Supplies and accessories” for ordering
	information.
	NOTE: The screens shown in this section are for the TWAIN
		Datasource. The screens displayed on your system may be
		different.
	1.	Open the pod and clean the imaging guides. Refer to the
		maintenance procedures in Chapter 5.
	2.	If the lamps have not been on, allow the lamps to warm up for 90
		seconds.
	3.	Center the side guides in the elevator tray and output tray.
	4.	Place the calibration target in the elevator tray.
	5.	Open the Scan Validation Tool.

6.Select Kodak Scanner: i600 or Kodak Scanner: i700. The main Kodak Scanner window will be displayed.

3-12	A-61500 May 2010

Image 28

Contents I600/i700 Series Scanners Contents Appendix a Introduction Scanner models New features Scanner features Speed/capacity Throughput Safety information MsdsUser precautions EMC statementsGas springs warning United StatesAcoustic emission Power systemConnection Getting Started For i700 Series Scanners only Microsoft Windows 7 64-bitMaking connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Turning the scanner on and off Using the ScannerStarting and stopping scanning Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Page Forward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeCalibrating the scanner Image calibration Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeAccessing the Enhanced Printer Changing the printer position Replacing the ink cartridge Page Replacing the blotter strips Replacing the ink cartridge carrier Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover 61500 May Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the pre Separation padReplacing the imaging GuidesTroubleshooting Indicator lightsLed display Description Accessing the Operator Log Page Page I600 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May Numerical Message I600 Series ScannersListing 61500 May I700 Series Scanners Message listing Enhanced Printer and Patch Readers for more Scanning Setup Guide for valid values Informational message. The pod was closed 61500 May I700 Series Scanners 61500 May Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/SpeedKodak, 2010. All rights reserved. TM Kodak