Kodak 6J7611A Using the Scanner, Turning the scanner on and off, Starting and stopping scanning

3 Using the Scanner

Turning the scanner on and off

This chapter provides the following operational procedures:

•Turning on/off the scanner

•Starting, stopping, pausing and resuming the scanner

•Document preparation

•Adjusting the side guides and output tray

•Scanning documents

•Feeding long documents

•Automatic, continuous and manual feeding

•Calibration

•Press the button on the scanner’s lower right-side (I) to power it up.

•Press the button on the scanner’s lower right-side (O) to power it down.

After you power up the scanner, wait until for it to complete self-test. When completed, the top green indicator light will remain on and constant. If this does not occur, refer to Chapter 6, “Indicator lights” for more information.

IMPORTANT: Always power up the scanner to its ready state before powering up or restarting the host computer.

Starting and stopping scanning

Scanning is controlled by integration software developed for your application. To start and stop scanning, refer to the documentation provided with your integration software.

If your application does not automatically start the scanner transport, begin the scanning process by pressing the Start/Resume button on the scanner.

NOTE: Before you start scanning, make sure the scanner is ready for operation, which is indicated by the top green indicator light being on and constant.

A-61500 May 2010 3-1