Adjusting the front of the output tray
Adjusting the output tray for long documents up to 43 cm (17 in.)
To raise the front of the output tray:
1.Lift the front of the output tray.
2.Swing the height adjustment wire out from underneath the output tray and insert it into the groove on the printer access cover.
3.When finished using the output tray in this position, tuck the height adjustment wire back into position and lower the output tray.
To adjust the output tray to accommodate long documents from 37 cm
14.5 in.) to 43 cm (17 in.):
1.Lift the front of the output tray and pull it out of the detent position.
2.Place the output tray in the forward detent position.
Forward detent positions
3.Gently push down on the left side of the output tray until in snaps into place.
4.Adjust the output tray end stop to accommodate long (or short) documents by pulling the end stop forward (or backward).
5.Remove the exit deflector.