Kodak 6J7611A manual Getting Started, For i700 Series Scanners only Microsoft Windows 7 64-bit

2 Getting Started

Site specifications

System requirements

Registering your scanner

Place the scanner:

•In a clean area with temperature and relative humidity typical of an office environment,

•on a stable, level work surface,

•within 1.52 metres (5 feet) of an electrical power outlet. IMPORTANT: Only use the scanner indoors in a dry location.

For more information about the scanner specifications, refer to Appendix B, Specifications.

Following is the minimum recommended system configuration to run Kodak i600/i700 Series Scanners.

NOTE: The actual performance of the system depends on the scanning application, choice of scanning parameters, and the host computer configuration. If the scanner is not performing at the optimal speed, a faster computer and/or more RAM may be necessary to obtain the rated throughput.

•Intel PC (or compatible) with a Pentium IV 2 GHz processor

•PCI slot

•512 MB RAM

•Monitor and mouse

•Supported operating systems:

-Microsoft Windows XP SP3 (32-bit)

-Microsoft Windows Vista (32-bit)

-Microsoft Windows 7 (32-bit)

-For i700 Series Scanners only: Microsoft Windows 7 (64-bit)

It is very important that you register your scanner so Kodak can provide you with the best possible service and support that helps maintain your continuous scanning. Registering your scanner will help us provide you with firmware and hardware updates as they become available.

The scanner must be registered before any service support can be provided.

You can register your scanner’s new equipment warranty online at www.kodak.com/go/DIwarrantyregistration.

For more information about Kodak’s service and support options, contact your reseller of Kodak Document Imaging products or visit us on the web at www.kodak.com/go/DIsupport.

A-61500 May 2010 2-1