Kodak 6J7611A manual I700 Series Scanners Message listing

i700 Series Scanners Message listing

Following is an alphabetic list of messages and corrective actions you can take if one of the following messages is encountered

Messages	ID#	Operator Message
Background accessory changed	381	The Background Accessory was changed while the scanner was
while powered up		powered on.
		• Turn the power off to the scanner, wait a few seconds and
		power the scanner back on.
		• If you get this message and you did not change the
		Background Accessory, clean the scanner.
Cable unplugged	319	Some device on the FireWire bus was unplugged/plugged in.
		• Check that all FireWire connectors are securely fastened.
Calibration failed	106, 331	• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.
		• Try to calibrate the scanner again. Be sure you are using the
		correct calibration target. See Chapter 3, “Calibrating the
		scanner”.
		• The calibration target is too small. A 12- x 12-inch calibration
		target is required for image calibration.
		• Calibration target is too narrow.
		• If the problem persists, call Service.
Calibration succeeded	105, 342	Informational message. The scanner has been successfully
		calibrated.
Call Service	Many ID	A condition was detected that may require repair.
	numbers	• Turn the power off to the scanner, wait a few seconds and
		power the scanner back on.
		• If the problem persists, call Service and provide the ID number
		of the error.
Cannot calibrate with white	184	The White Background Accessory is installed in the scanner
background		while the scanner is trying the calibrate.
		Remove the White Background Accessory before calibrating the
		scanner.
Check document preparation	123, 135,	• The gap between your documents is too small.
	81	• Make sure the leading edges of the documents are aligned.
		See Chapter 3, “Document preparation” for more information.
		• Check the condition of your feed module and separation roller
		tires and your pre-separation pad. Clean and replace if
		necessary.
Check imaging guides and lamps	149, 178,	• Verify that the imaging guides are installed correctly. See
	139	Chapter 5, Maintenance.
		• Clean both sides of the imaging guides and lower glass plate
		between the lamps.
		• Check that the white patch on the imaging guides is clean and
		in good condition.
		• If the problem persists, call Service.
Clean lower imaging guide	294	The lower imaging guide is dirty or there may be a small piece of
		paper in the imaging guide area.
		• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.

A-61500 May 2010 6-13