Xerox PE120i manual Network Communication Setup, Automatically setting TCP/IP Addresses

Network Communication Setup

Automatically setting TCP/IP Addresses

Installation

1

2

3

At the WorkCentre PE120i, perform these steps:

¾Press [Menu] until you see Network Setup on the top line of the display.

¾Press or until Configure Network is displayed and press [Enter].

¾Press or until TCP/IP is displayed and press [Enter].

8.Network Setup [Reset Network]

8.Network Setup [Config. Network]

Basic Network

You can use DHCP or BOOTP to automatically configure TCP/ IP on the machine.

4 ¾ Press or until the required setting method is displayed and press [Enter].

Config Network

[TCP/IP]

TCP/IP

[DHCP]

After a short period of time, the network will allocate the required addresses.

5 Print a System Data sheet to check the addresses (see Printing a System Data2-6).

Xerox WorkCentre PE120i System Administration Guide Page 2-5