Print Driver Installation for Networked Printers
Windows XP (TCP/IP)
NOTE: Windows XP supports printing via TCP/IP as standard when TCP/IP is installed on a Windows XP Workstation.
Use the Add Printer Wizard to add the WorkCentre PE120i to the network.
¾Select [Start], select [Printers and Faxes].
1
¾Select [Local Printer attached to this computer], uncheck the box labelled
2[Automatically detect and install my Plug and Play printer.]and then select [Next] to display the dialog box listing available ports.
¾Select [Create a new port] to display the Printer Ports dialog box.
3Select [Standard TCP/IP Port] and select [Next] to display the Add Standard TCP/IP Port dialog box.
Enter the IP Address of the printer in the [Name or address of printer] field (you can optionally enter a friendly name for the printer port you are creating or use the default name created). Then select [Next] to continue.
If the network printer settings are not automatically detected, click on the [Custom] button to setup the network printer port settings.
It is recommended that you select [RAW] as the Print Protocol. If you prefer to use LPR:
Select [LPR] as the Print Protocol.
Enter [lp] (in lower case) in the [LPR print queue] field. Uncheck the box labelled [LPR Byte Counting Enabled] Check the box labelled [SNMP Status Enabled].
The [Community Name] should normally be set to “public” (unless you have configured the device to have a custom SNMP community name) and the [SNMP Device Index] should be set to 1.
Select [OK].
¾The Add Printer Wizard will then request that you select the driver to be used for this
4printer.
Insert the CD ROM with the WorkCentre PE120i drivers into the workstation and select [Have Disk].
Page | Xerox WorkCentre PE120i System Administration Guide |