Xerox PE120i manual Frame

Network Installation Using Internet Services

NOTE: Click the [Undo] button to cancel any changes made and return to the previous values.

¾You can Add or Edit a Trap Destination Address by making the following selections and

6 settings in the Trap Destination Addresses section of the frame:

Click the [Add] button or the [Edit] button to add a new address or amend an existing address.

In the IP Address Destination section, enter or amend the IP Address and UDP Port Number.

In the Traps section, enter the Trap Community Name and check the boxes corresponding to the required Traps to be Received.

¾Click the [Apply] button to implement any changes and return to the first screen.

NOTE: Click the [Undo] button to cancel any changes made and return to the previous values.

¾You can Delete a Trap Destination Address from the Trap Destination Addresses section

7 of the frame:

Highlight the required Address/Socket or Port and click the [Delete] button.

8 ¾ Click the [Apply] button to implement any changes.

NOTE: Click the [Undo] button to cancel any changes made and return to the previous values.

9	¾ Select the [Status] tab and then select [Reset Network Controller] to enable the
	selections to take effect.

Page 6-18 Xerox WorkCentre PE120i System Administration Guide