Xerox PE120i manual Http

Network Installation Using Internet Services

HTTP

Use these instructions to setup HTTP using CentreWare Internet Services.

NOTE: The HTTP settings for the device will have been setup when completing the Enabling CentreWare Internet Services section.

To complete the installation of the device, perform these steps:

1	¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).
3	¾ At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
	[Properties] tab.
4	¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
	and then select the [+] symbol to the left of the Protocol folder.
5	¾ Check the HTTP Configuration details are correct. If necessary.
	Enter the [Keep Alive Timeout] in seconds from 5 to 99.
	Enter the [Maximum Connections] from 5 to 16.
6	¾ Click the [Apply] button to implement any changes.

NOTE: Click the [Undo] button to cancel any changes made and return to the previous values.

¾Select the [Status] tab and then select [Reset Network Controller] to enable the

7	selections to take effect.
8	¾ Continue with Test Print.

Page 6-26 Xerox WorkCentre PE120i System Administration Guide