Using CentreWare Internet Services
Introduction
CentreWare Internet Services uses the embedded HTTP Server on the WorkCentre PE120i to allow communication with the WorkCentre PE120i if you have a Web Browser with access to the Internet or Intranet. By entering the IP Address of the WorkCentre PE120i as the URL (Universal Resource Locator) in the Browser, direct access to the WorkCentre PE120i is available.
NOTE: Microsoft Internet Explorer version 4.x or later should be used. Other browsers may work, but could produce unexpected results.
Many of the selections and settings needed to install WorkCentre PE120i on a network can be made using Internet Services, eliminating steps that would otherwise need to be performed at the WorkCentre PE120i Control Panel.
Many of the features available within Internet Services will require an admin user name and password. A user will only be prompted for an admin name and password once in a single browser session.
Before the Internet Services feature can be used for installing WorkCentre PE120i on a network it must be enabled. There are two stages required to enable Internet Services:
¾Network Communication Setup
This requires the WorkCentre PE120i to be setup for Internet Services.
¾Enable Internet Services
¾Make settings to the appropriate network
NOTE: When making more than one configuration change please complete all the changes in one go and then carry out a reboot.
Network Installation Using Internet Services
Xerox WorkCentre PE120i System Administration Guide | Page |