Xerox PE120i manual Tcp/Ip

Network Installation Using Internet Services

TCP/IP

Use these instructions to install the device on a TCP/IP network using CentreWare Internet Services.

Installation Procedure

There are two stages required to install the device on a TCP/IP network using CentreWare Internet Services:

¾Configure the WorkCentre PE120i

This procedure explains how to use CentreWare Internet Services to configure the device.

¾Test Print

A print job should be submitted to ensure the device has been installed and configured correctly.

Configure the WorkCentre PE120i

NOTE: The TCP/IP settings for the device will have been setup when completing the Enabling CentreWare Internet Services section.

To complete the installation of the device, perform these steps:

1 ¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).

2 ¾

3 ¾

4 ¾

5 ¾

At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the [Properties] tab.

Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and then select the [+] symbol to the left of the Protocols folder.

Select [TCP/IP] and check the Protocol Configuration details are correct. If any of the details are incorrect then enter the correct information.

In the Physical Connection field, Ethernet will be the default setting.

Select the checkbox to enable TCP/IP.

Enter the [Host Name].

Choose the [IP Address Resolution] required.

Page 6-14 Xerox WorkCentre PE120i System Administration Guide