Xerox PE120i manual Lpr/Lpd, Enter the Port Number

Network Installation Using Internet Services

LPR/LPD

Use these instructions to enable or disable LPR/LPD using CentreWare Internet Services.

Installation Procedure

There are two stages required to install the device on a LPR/LPD network using CentreWare Internet Services:

¾Configure the WorkCentre PE120i

This procedure explains how to use CentreWare Internet Services to configure the device.

¾Test Print

A print job should be submitted to ensure the device has been installed and configured correctly.

Configure the WorkCentre PE120i

To complete the installation of the device, perform these steps:

1 ¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).

¾At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the

2 [Properties] tab.

¾Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,

3	and then select the [+] symbol to the left of the Protocols folder.
4	¾ In the Properties frame, within the Protocols folder, select [LPR/LPD].
5	¾ Select the checkbox to enable LPR/LPD.
	Enter the [Port Number].

NOTE: While you can change the port number at which the WorkCentre PE120i will accept LPR print jobs, it is recommended that you do this ONLY with extreme caution as most LPR spoolers are set to send print jobs to the default port number, 515.

6 ¾ Click the [Apply] button to implement any changes.

Page 6-20 Xerox WorkCentre PE120i System Administration Guide