SpectraLink 8000 Telephony Gateway Administration Guide
The following settings use the US Robotics® Sportster® modem. Other modem models may be used, but the particular model’s settings will have to be adapted to conform to those listed in the following table.
Configure modem internal settings (US Robotics Sportster)
1. | Connect the modem to a PC using a standard modem cable. Plug | ||
| the | ||
| connector into the modem’s port. | ||
2. | Using a standard communications package such as ProComm | ||
| Plus or HyperTerminal™, bring up the modem and type the | ||
| following commands. Press Enter after typing each command. | ||
|
|
| |
Command | Description |
| |
AT&F1 | Loads factory default settings |
| |
AT&H0 | Sets Transmit Data Flow control to disabled |
| |
|
|
| |
AT&R1 | Sets modem to ignore Request to Send (RTS) |
| |
AT&W0 | Saves the configuration |
| |
|
|
|
|
3. | Power off the modem, and then turn it back on. | ||
4. | Type: ATI4 and press Enter. The settings should match those | ||
| shown in the following figure, which was taken from ProComm | ||
| Plus. |
|
|
50 | PN: |