PD-01 PROFIBUS-DP Module
Insert the connector into the PROFIBUS-DP Interface (DB9), and tighten screws to secure the connector in place.
Power Supply
The power of PD-01 is supplied from VFD series Drive. Firmware version should
conform the VFD series Drives as table listed in the page 2. No external power needed. The +15VDC power is applied to PD-01 directly via a specific 6-PIN communication cable (This 6-PIN cable is packed together with PD-01).
NOTE:
Though the PD-01 power is supplied from VFD series Drives, it will energized till power to VFD series Drives is applied
RJ11
| | | +15V |
1 | | 6 | GND |
|
1: +15V | 2: GND | |
3: SG- | 4: SG+ | |
5: not used | 6: not used | |
SG-
SG+ Not used
8DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED