SMC Networks PL241, AHB SRAM/NOR About this manual, Product revision status, Intended audience

Page 10

Preface

About this manual

This is the Technical Reference Manual (TRM) for the PrimeCell AHB SRAM/NOR Memory Controller.

Product revision status

The rnpn identifier indicates the revision status of the product described in this manual,

where:
rn	Identifies the major revision of the product.
pn	Identifies the minor revision or modification status of the product.

Intended audience

This manual is written for system designers, system integrators, and verification engineers who are designing a System-on-Chip(SoC) device that uses the AHB MC. The manual describes the external functionality of the AHB MC.

Using this manual

This manual is organized into the following chapters:

Chapter 1 Introduction

Read this chapter for a high-level view of the AHB MC and a description of its features.

Chapter 2 Functional Overview

Read this chapter for a description of the major components of the AHB

MC and how they operate.

Chapter 3 Programmer’s Model

Read this chapter for a description of the AHB MC registers.

Chapter 4 Programmer’s Model for Test

Read this chapter for a description of the additional logic for integration testing.

Chapter 5 Device Driver Requirements

Read this chapter for a description of device driver requirements for the

Static Memory Controller (SMC).

x

Copyright © 2006 ARM Limited. All rights reserved.

ARM DDI 0389B

Image 10

Contents PrimeCell AHB SRAM/NOR Memory Controller PL241 Technical Reference Manual PrimeCell AHB SRAM/NOR Memory Controller PL241Copyright 2006 ARM Limited. All rights reserved Contents Chapter Programmer’s Model for Test List of Tables List of Tables List of Figures Figure A-1 AHB MC PL241 grouping of signals Preface Feedback onProduct revision status Using this manualAbout this manual Intended audienceTypographical ConventionsBold Timing diagrams SignalsFurther reading NumberingARM publications Feedback on this product FeedbackFeedback on this manual Introduction This section describes About the AHB MCSMC on AHB interface AHB to APB bridge3 SMC Low-power interfacesClock domains Supported devices Intel W18 series NOR FLASH, for example 28f128W18tdIntroduction Copyright 2006 ARM Limited. All rights reserved Functional Overview Functional description This section is divided intoAHB clock domain Smcmreset0nLow-power interface Static memory clock domainFormat on SMCMain blocks of the SMC are Interrupts onFormat SMC interfaceAPB slave interface Memory managerPad interface InterruptsAHB interface operation Functional operationAHB fixed burst types Undefined length Incr bursts Bufferable bit of the Hprot signalBroken bursts Read after write hazard detection buffer AHB response signalsLocked transfers Registered Hwdata Big-endian 32-bit modeRemoval of AHB error response logic AHB to APB bridge operationClock domain operation Ahbc memory map1lists the static memory clocking options Low-power interface operationStatic memory clocking options Static memory clocking optionsWhere Domain is ahb or smc An active output DomaincactiveAccepting requests Operating states SMC functional operationSMC states are as follows Clocking and resets ClockingResets Smcuserstatus70 Miscellaneous signalsSmcuserconfig70 Smcagtm0syncFormat block APB slave interface operationHazard handling Sram memory accesses Memory burst length Chip configuration registers Low-power operationMemory manager operation 11 Chip configuration registers Device pin mechanism Direct commandsSoftware mechanism 12 Device pin mechanism 13 Software mechanism Interrupts operation Sram timing tables and diagramsMemory interface operation Asynchronous read opmode chip register settings Asynchronous read Sram cycles register settings4and -5list the smcopmode00-3 and Sram Register settings 14 Asynchronous readAsynchronous write opmode chip register settings 6and -7list the smcopmode00-3 and Sram Register settingsAsynchronous write Sram cycles register settings 10and -11list the smcopmode00-3 and Sram Register settings 8and -9list the smcopmode00-3 and Sram Register settings10 Page read opmode chip register settings 12 Synchronous burst read opmode chip register settings 12and -13list the smcopmode00-3 and Sram Register settings13 Synchronous burst read Sram cycles register settings 19 Synchronous burst read 14and -15list the smcopmode00-3 and Sram Register settings 20 Synchronous burst read in multiplexed-mode16 Synchronous burst write opmode chip register settings 16and -17list the smcopmode00-3 and Sram Register settings17 Synchronous burst write Sram cycles register settings 18and -19list the smcopmode00-3 and Sram Register settings 22 Synchronous burst write in multiplexed-mode20and -21list the smcopmode00-3 and Sram Register settings B0100 B0110 B001TCEOE is only required if wait is asserted when oen goes LOW TWC = ARM DDI 0389B Programmer’s Model About the programmer’s model 2shows the SMC configuration register map Register summaryName Base offset Type Reset value Description 1lists the SMC RegistersRegister summary SMC Memory Controller Status Register at Register descriptionsThis section describes the SMC registers 2lists the register bit assignments3lists the register bit assignments SMC Memory Interface Configuration Register atBits Name Function SMC Set Configuration Register at Smcmemccfgset Register bit assignments5lists the register bit assignments SMC Clear Configuration Register at 0x100C4lists the register bit assignments Smcmemccfgclr Register bit assignments Bits Name Function6lists the register bit assignments SMC Direct Command Register atSmcdirectcmd Register bit assignments SMC Set Cycles Register at Lists the register bit assignmentsSMC Set Opmode Register at 12 smcsetopmode Register bit assignments8lists the register bit assignments Smcsetopmode Register bit assignments Memory width mw fieldSMC Sram Cycles Registers 0-3 at 0x1100, 0x1120, 0x1140 SMC Refresh Period 0 Register atSmcrefreshperiod0 Register bit assignments 10lists the register bit assignments SMC Opmode Registers 0-3 at 0x1104, 0x1124, 0x114411lists the register bit assignments 11 smcopmode Register bit assignments SMC User Status Register at12lists the register bit assignments 12 smcuserstatus Register bit assignments13 lists the register bit assignments SMC User Configuration Register at13 smcuserconfig Register bit assignments Bits Name DescriptionSMC Peripheral Identification Register Following section describe the smcperiphid Registers15 smcperiphid0 Register bit assignments Bits Name Function 16 smcperiphid1 Register bit assignments Bits Name Function 17 smcperiphid2 Register bit assignments Bits Name FunctionSMC PrimeCell Identification Registers 0-3 at 0x1FF0-0x1FFC 19shows the register bit assignmentsSMC PrimeCell Identification Register These registers cannot be read in the Reset stateFollowing sections describe the smcpcellid Registers 20 smcpcellid0 Register bit assignments Bits Name Function22 smcpcellid2 Register bit assignments Bits Name Function 23 smcpcellid3 Register bit assignments Bits Name FunctionProgrammer’s Model for Test SMC integration test registers Test registers are provided for integration testingSMC Integration Configuration Register at 0x1E00 Lists the SMC integration test registersIntegration Inputs Register at 0x1E04 Smcintinputs Register bit assignments Bits Name FunctionIntegration Outputs Register at 0x1E08 StateDevice Driver Requirements Memory initialization SMC and memory initialization sheet 1 SMC and memory initialization sheet 2 Where = denotes the appropriate chip select SMC and memory initialization sheet 3ARM DDI 0389B Signal Descriptions About the signals list Where Ahbc = AHB Configuration signalsTable A-1lists the clock and reset signals Clocks and resetsName Type Source Description Destination Where = 0 or C, where C = Configuration AHB signalsTable A-2lists the AHB signals Table A-2 AHB signalsSMC memory interface signals Table A-3lists the SMC memory interface signalsTable A-4lists the SMC miscellaneous signals SMC miscellaneous signalsTable A-4 SMC miscellaneous signals Low-power interface Table A-5lists the low-power interface signalsTable A-6 Configuration signal Configuration signalTable A-6lists the configuration signal Name Source Description Type DestinationTable A-7 Scan chain signals Table A-7lists the scan chain signalsScan chains ARM DDI 0389B Advanced High-performance Bus AHB Advanced Microcontroller Bus Architecture AmbaSee also Little-endian memory Advanced Peripheral Bus APBData bus IncrementedAn 8-bit data item Multi-master operationThat event resource is Unpredictable Divisible by fourSee Unpredictable Other purposesRemapping Has been completedWritten as 0 and read as ReservedGlossary-6