Seagate DL585 manual Front fan cage

Page 40

Front fan cage

To remove the front fan cage:

1.Power down the server. See “Powering down the server” earlier in this chapter.

2.Extend the server from the rack. See “Extending the server from the rack” earlier in this chapter.

3.Remove the access panel. See “Removing the access panel” earlier in this chapter.

4.Remove the processor memory boards. See “Processor memory boards” earlier in this chapter.

5.Remove the PCI-X expansion boards. See “PCI-X expansion boards” earlier in this chapter.

6.Remove the SCSI cables. See “SCSI cables” earlier in this chapter.

7.Loosen the three thumbscrews that secure the front fan cage to the chassis .

NOTE: It is not necessary to remove the fans before removing the fan cage. The fan cage can be removed with the fans installed.

8.Remove the hot-plug fans in the front fan cage. See “Hot-plug fans” earlier in this chapter.

9.Lift the front fan cage from the chassis .

Figure 36 Removing the front fan cage

Reverse the steps to replace the front fan cage.

Removal and replacement procedures 40

Image 40

Contents HP ProLiant DL585 Server Page Contents NIC Bbwce Where to go for additional help About this guideAudience assumptions Technician notesIntegrated Management Log Telephone numbersIllustrated parts catalog Customer self-repair programMechanical components spare parts list Mechanical components exploded view‡REQUIREMENT System components spare parts list System components exploded viewPPM Sdram ‡REQUIREMENT Removal and replacement procedures Safety considerationsPreparation procedures Electrostatic dischargePowering down the server Locating and removing the Torx T-15 tool Extending the server from the rackRemoval and replacement procedures Removing the access panel Installing the access panelRemoving the server from the rack Processor memory boards Processor memory board population guidelinesPPM Processor Removing a processorRemoval and replacement procedures Memory options Minimum memory requirementsRemoving a Dimm Hard drive blanks Drive replacement precautionsHot-plug Scsi hard drives Hot-plug SAS or Sata hard drives SAS or Sata hard drive cage Power transfer board Removal and replacement procedures Power supply blank Hot-plug power supplies Hot-plug fans Universal media drivesRemoving a drive from bay Front bezel Power button/LED assembly Expansion boards Performance balancing PCI-X expansion boardsScsi cables Front fan cage Pass-through board QuickFind diagnostic display board and lightpipe Rear fan cage Bbwc assembly Scsi backplane System battery Locating the battery on the system boardRemove the existing battery System board Removal and replacement procedures AC filter cable assembly Cutting the cable tie-wrapsRemoval and replacement procedures Removal and replacement procedures Re-entering the server serial number Diagnostic tools Diagnostic toolsPost Server component identification ConnectorsRear panel Scsi backplane board connectors Scsi backplaneDimm slots Processor and PPMLEDs Front panelQuickFind diagnostic display HP ProLiant DL585 Server User Guide onHot-plug Scsi hard drives Hot-plug Scsi hard drive LEDsHot-plug Scsi hard drive LED combinations Hot-plug SAS or Sata hard drives Hot-plug SAS or Sata hard drive LED combinationsHot-plug SAS or Sata hard drive LED combinations Hot-plug power supplies Hot-plug fansNIC Bbwce Internal diagnostic display System board switches System maintenance switch SW3System ID switch SW4 System ID switch SW4 System ID Switch SW4ILO/Redundant ROM override switch SW5 Non-maskable interrupt switch Rear unit identification LED switchTroubleshooting If the server does not start Diagnostic steps Is the system power LED off?Is the internal health LED green? Servers Troubleshooting Guide Is the monitor displaying information? Error message Problems after initial boot Provided in the Factory-Installed Two-processor memory board configuration Troubleshooting a failed processorFour-processor memory board configuration Other information resources Specifications Server specificationsIndex UID LED