Pitney Bowes J693 manual Die-cut stock remove, Notched stock place, Reflective media place

Step	Operator Action	Displayed Message	Comment
9 Proceed according to the		"￿#￿	Sets the
		￿￿￿"￿￿￿￿￿]<<<_
	media type:		parameter for
	Die-cut stock: remove		the ‘gap’ or
		-OR-
			‘mark’ value.
	approximately six inches		‘yyy’ is a
	of label material from the	￿
			numerical value
	backing (liner) and place
			representing the
	the backing under the
			current sensor
	Sensor Eye Mark.
			reading.
	Notched stock: place the		If the ‘Sensor
	notched area in the sensor
			Type’ is set to
	and adjust the Sensor Eye
			‘Continuous’,
	Mark over the notch.
			this step is
	Reflective media: place		skipped, going
	the black mark (face		directly into
	down) in the sensor and		Step 10.
	adjust the Sensor Eye
	Mark over the black
	mark.
	Press any key to continue.

Note: After the Media Sensor has been adjusted, do not readjust the position.

(Continued next page)

44 J693