Datamax ST-3210, SV-3306, ST-3306, SV-3210 Approved Ticket Stocks, Manufacturer Material Comment

Page 57

6.1Approved Ticket Stocks

For optimum print quality and maximum printhead life, Datamax recommends using a ticket stock from the following table. Contact a Datamax Media Representative at (407) 523-5650 with any questions regarding your specific application.

Manufacturer

Material

Comment

 

 

 

Best quality for high-speed printing,

Ricoh

150 TLA 190

10 inches per second (IPS), and high

 

 

quality applications. Recommended

 

 

for use with the ST/SV-3306.

 

Ricoh

120 TLA 1901

Mid range. Best

with

print

speeds

up to 8 IPS.

 

 

 

 

 

 

 

 

Kanzaki

KT-370

Mid range. Best

with

print

speeds

up to 5 IPS.

 

 

 

 

 

 

 

 

If you choose to use another stock, ensure it meets the requirements listed in the Section 6.0, in addition to the following:

∙ The ticket stock should have a minimum .4 inch (10.2 mm) wide Quiet Zone running the entire length of the ticket.

∙ The TOF Mark should be centrally located over the Quiet Zone and measure a minimum of .5 inch (12.7 mm) wide and .125 inch (3.175 mm) long.

ST/SV-3210 and ST/SV-3306

47

Image 57
Contents ST/SV 3210 & ST/SV Operator’s Manual Page Copyright Information Page Agency Compliance and Approvals Important Safety Instructions Contents Troubleshooting Warranty Information Glossary Index Page Printer Overview About the PrinterST Table Model Standard Features Optional Features ST/SV-3210 and ST/SV-3306 Unpacking the Printer Getting StartedAdditional Requirements InspectionAC Selection Switch Required Fuse Rating AC Voltage ConfigurationInterfacing the Printer Printer power and interface connections ST Models Loading Ticket StockPage SV Models Installing a Memory Module ST Models SV Models Using the Front PanelTicket Exit Two functions Three functionsResident Formats Configuration TicketTest Pattern Ticket Internal Test Ticket Resetting the Printer Warm ResetFactory Default Reset TOF Sensor Adjustment Adjusting Maintaining the PrinterST Model TOF Sensor Adjustment SV Model TOF Sensor Adjustment Stock ID Selections Position Start of Print & Cut/Tear Adjustment Operational Database Modification Auto Bit word Parit Database Modification Example Printer will turn off the On-Line Indicator and printRecommended Cleaning Schedule Area Method Interval MaintenanceST Models Raise Cleaning the PrintheadCleaning the Platen Roller TOF Sensor Cleaning Ticket Detect Sensor Cleaning Exterior Surface Cleaning Interior CleaningTroubleshooting Troubleshooting TipsTry this solution… Reconfigure to match, see Section Not meet specifications see Section Try this solution… Hex Dump Mode ST/SV-3210 and ST/SV-3306 Specifications SpecificationsEnvironmental Mechanical Ticket Stock Requirements Manufacturer Material Comment Approved Ticket StocksST/SV-3210 and ST/SV-3306 Appendix a Ascii Control Code ChartAscii Control Code Chart Appendix B Available Fonts and BarcodesDPL Fonts DPL Font Samples ST/SV-3210 and ST/SV-3306 Font Number Font ID Font Size Box Size Dtpl FontsDtpl Font Samples Font Barcode Type Length Checksum Valid Characters DPL BarcodesDPL Bar Code Samples Bar Code I Codabar Bar Code K Plessey Barcode T Telepen Dtpl Barcodes Cable Listings Appendix CST/SV-3210 and ST/SV-3306 SV Model Mounting Dimensions Top Plate DimensionsAppendix D Side Dimensions Thermal Printhead, Belts, and Platen Roller PrinterGeneral Warranty Provisions Warranty Service ProceduresLimitation of Liability ST/SV-3210 and ST/SV-3306 Glossary ST/SV-3210 and ST/SV-3306 ST/SV-3210 and ST/SV-3306 ST/SV-3210 and ST/SV-3306 Index Ticket stock, 10 12, 21 23, 28, 29 38, 39, 46, 47, 69