Datamax ST-3306, SV-3306, ST-3210, SV-3210 Resetting the Printer, Warm Reset, Factory Default Reset

Page 30

3.6Resetting the Printer

There are two different reset levels possible for the printer:

3.6.1Warm Reset

To reset the printer and return to the on-line mode: Press the PAUSE button to go off-line and then press the F1 + F3 buttons simultaneously.

3.6.2Factory Default Reset

To return the printer to default database settings (see the table below), perform the following procedure.

ŒTurn the printer ‘Off’.

Press and hold the PAUSE/F1, FEED/F2 and TEST/F3 buttons while turning ‘On’ the printer.

ŽAfter the Fault Indicator flashes (approximately 20 seconds), release all three buttons.

For verification, a Configuration Ticket can be printed. The printout will reflect default settings until new configuration data is sent to the printer.

Default Database Settings

 

Function

ST/SV 3210 Values

ST/SV 3306 Values

 

 

Memory Configuration: [1]

128

128

 

 

Internal Module

 

 

Scalable Fonts

64

64

 

 

Character Set:

Standard

Standard

 

(DPL parser mode only)

 

 

 

 

 

Cutter

Auto Detect

Auto Detect

 

Parser Mode:[2]

DTPL

DTPL

 

Print Speed: [3]

8

4

 

 

Slew Speed: [3]

8

4

 

 

Backup Speed: [3]

3

3

 

 

Stock ID

5

5

 

 

Print Width

1.89 inches (48 mm)

1.92 inches (49 mm)

[1]Memory allocations are represented in 4KB units each and modifiable only when in the DPL parser mode.

[2]The parser mode setting may arrive factory-configured to meet your application; otherwise see Section 4.3.1.

[3]All speed values given in Inches Per Second.

20

ST/SV-3210 and ST/SV-3306

Image 30
Contents ST/SV 3210 & ST/SV Operator’s Manual Page Copyright Information Page Agency Compliance and Approvals Important Safety Instructions Contents Troubleshooting Warranty Information Glossary Index Page Printer Overview About the PrinterST Table Model Standard Features Optional Features ST/SV-3210 and ST/SV-3306 Getting Started Unpacking the PrinterInspection Additional RequirementsAC Voltage Configuration AC Selection Switch Required Fuse RatingInterfacing the Printer Printer power and interface connections Loading Ticket Stock ST ModelsPage SV Models Installing a Memory Module Using the Front Panel ST Models SV ModelsTicket Exit Three functions Two functionsConfiguration Ticket Resident FormatsTest Pattern Ticket Internal Test Ticket Resetting the Printer Warm ResetFactory Default Reset Adjusting Maintaining the Printer TOF Sensor AdjustmentST Model TOF Sensor Adjustment SV Model TOF Sensor Adjustment Stock ID Selections Position Start of Print & Cut/Tear Adjustment Operational Database Modification Auto Bit word Parit Printer will turn off the On-Line Indicator and print Database Modification ExampleMaintenance Recommended Cleaning Schedule Area Method IntervalCleaning the Printhead ST Models RaiseCleaning the Platen Roller TOF Sensor Cleaning Ticket Detect Sensor Cleaning Interior Cleaning Exterior Surface CleaningTroubleshooting Troubleshooting TipsTry this solution… Reconfigure to match, see Section Not meet specifications see Section Try this solution… Hex Dump Mode ST/SV-3210 and ST/SV-3306 Specifications SpecificationsEnvironmental Mechanical Ticket Stock Requirements Approved Ticket Stocks Manufacturer Material CommentST/SV-3210 and ST/SV-3306 Ascii Control Code Chart Appendix aAscii Control Code Chart Appendix B Available Fonts and BarcodesDPL Fonts DPL Font Samples ST/SV-3210 and ST/SV-3306 Dtpl Fonts Font Number Font ID Font Size Box SizeDtpl Font Samples DPL Barcodes Font Barcode Type Length Checksum Valid CharactersDPL Bar Code Samples Bar Code I Codabar Bar Code K Plessey Barcode T Telepen Dtpl Barcodes Appendix C Cable ListingsST/SV-3210 and ST/SV-3306 SV Model Mounting Dimensions Top Plate DimensionsAppendix D Side Dimensions Printer Thermal Printhead, Belts, and Platen RollerWarranty Service Procedures General Warranty ProvisionsLimitation of Liability ST/SV-3210 and ST/SV-3306 Glossary ST/SV-3210 and ST/SV-3306 ST/SV-3210 and ST/SV-3306 ST/SV-3210 and ST/SV-3306 Index Ticket stock, 10 12, 21 23, 28, 29 38, 39, 46, 47, 69