Citizen Systems Model CMP-10 manual

n denotes the number of bytes for horizontal size of a bit image. d denotes a graphic data.

In 10(Hex) mode, data is in n ⋅ 24 bytes.

For data in 11(Hex) mode, the size in non-compressed format shall be n ⋅ 24 bytes. For data in 12(Hex) mode, the size in non-compressed format shall be n ⋅ a bytes.

Compression system in 11(Hex) and 12(Hex) is the same as that for PCX file format (monochrome). The printer receives the compressed data, reproduces it in the following format and prints as bit-image data.

AIf either of upper two bit of input byte is 0, the byte is treated as graphic data.

If both of upper two bit of graphic data to be printed are 0, it is necessary to send the data to printer in ÒBÓ format described below.

B If both of upper two bit of input byte are 0, the remaining 6 bit specifies the times the data is repeated. The number of times to be repeated is specified in 0-3F(Hex). The byte follows this byte is treated as graphic data to be repeated.

Graphics data should line up from left to right and from top to bottom.

Ñ 16 Ñ

12

Compressed data of a dots vertical

11

Compressed data of 24 dots vertical (Argument ÒaÓ and 00(Hex) are not used.)

10

Non-compressed data of 24 dots vertical (Argument ÒaÓ and 00(Hex) are not used.)

m (Hex)

Type

Specifying the Bit Image Mode (PCX format)

<1B>H<2A>H<m><n>{<a><00>H} [d]k

{m= 10, 11 or 12(Hex)} {0 =< n =< 30(Hex)} {0 =< a =< 18(Hex)} {0 =< d =< FF(Hex)} {0 =< k =< n x 18(Hex)}

Designates a bit image of n*8 dots horizontal by 24 or a dots vertical. Dot density is fixed at 203 dpi both horizontally and vertically.

Bit image mode selected by the value of m is shown in the following table.

This command has one more version.

[Function]

[Code]

[Range]

[Outline]