Novatel user manual SMART-AG Power/Communications Development kit Cable

Technical Specifications Appendix A

A.2.1 SMART-AG Power/Communications Development kit Cable

The SMART-AG cable that accompanies the SMART-AG, see Figure 15 below, provides a means of supplying power from a battery while operating in the field. The exposed wires (red for positive and black for negative) can then be connected to a 12 or 24V vehicular power circuit (or equivalent) protected by a 5A fast blow fuse (user supplied). The cable also has two DB-9 connectors. One can accommodate a PC/laptop serial (RS-232) communication port and the other can connect to a modem or radio transmitter to propagate differential corrections (please refer to your user-supplied modem or radio transmitter user guide for more information on its connectors).

In addition, there are a number of bare wires where the outer insulation is cut away but the wires beneath are intact. See Table 7 on Page 54 for their pinouts. For more information on mating connectors and part numbers, see Table 8 on Page 55.

This cable is RoHS compliant and its part number is 01018256.

5A Fast Blow Fuse

(User Supplied)

SEE DETAIL B

BLACK

BATT-

SEE DETAIL A

J1

SEE DETAIL C

STRIP INSULATION FROM

12WIRES AND CRIMP AMP/TYCO TERMINAL # 770520-3 OR 770854-3

PER TYCO APPLICATION SPEC

114-16016

SCALE 0.500

RED,

BATT +

	BLUE,					WHT-BLK,
	ER_OUT
						ER GND
		WHITE, MKI
		WHT-BLK,
J2	COM 1	MKI GND
				ORANGE, PPS
					WHT BLK,
J3	COM 2			PPS GND
			YELLOW,
	DETAIL A			CAN1+
	SCALE 1.000	GREEN,
		CAN1-
	PIN 9

PIN 6			PIN 5
PIN 10			PIN 1
			PIN 1
			PIN 6
PIN 14		PIN 2	DETAIL C
	PIN 9		SCALE 1.000
DETAIL B
SCALE 1.000

Figure 15: SMART-AG Development Kit Cable

SMART-AG User Manual Rev 2 53