Panasonic WJ-SX650 manual Board Mounting Procedure

■Board Mounting Procedure

The following is the procedure to mount a set of video input or output board into the expansion slot of the unit.

Note: Before the procedure, power off the unit.

1. Remove the expansion slot panel from the rear side.

SIGNAL GND

SIGNAL GND

3. Remove the front panel by loosening the screws.

OPERATE

Matrix	SwitcherWJ-
	SX6
	50

4.Mount the main board by hooking the board stoppers on the board stopper angles at the front side, and by

pushing down the board stoppers.

2.Mount the rear boards (x 3) into the expansion slot, and fix these boards with screws supplied to the rear boards.

SIGNAL GND

SIGNAL GND

IN X-2 board

IN X-1 board

Notes:

•The board name (IN X-1, OUT X-1, etc.) is marked at the lower right corner of each board mounting angle. When mounting the rear boards, match the board names with the markings at board mounting angles.

•To mount a set of video input board into the expansion slot, dismount the IN B-3 board, and then mount the OUT X-3.

Notes:

•Remove 3 screws surely at the arrow marking when dis- mounting.

•When mounting, match the main board surely with the rear board.

•When mounting, insert the main board surely into slits.

•Do not hit the boards against the chassis of the unit.

20