Panasonic WJ-SX650 manual PS·Data Mode Connection, Example

ON

Line termination: ON (#2: ON)

1 2

DATA 4

DATA 3

DATA 2

DATA 1

TERM.ON

ON

TERM.OFF

4

3

2

1

OFF

ON

Video Output Board 2

HDR4/TMNL8

HDR3/TMNL7

TMNL6

TMNL5

Video Output Board 1

HDR2/TMNL4

HDR1/TMNL3

TMNL2

TMNL1/PS DATA

MODE

MODE

MODE

DATA

MODE

MODE

DATA

MODE

OUT

EXTENSION 1

IN

TERM.

OUT X-3

16

15

14

13

12

11

10

9

8

7

6

5

4

3

2

1

MONITOR OUT

OUT X-2

VS IN

VS OUT

Video Output Board 1 Only

ALARM OUT 2

ALARM OUT 1

VS OUT

SERIAL

OUT X-1

(THRU)

DATA2

DATA1

Video output rear boards

A B

1	2	3	1	2	3	1	2	3	1	2	3	1	2	3
4	5	6	4	5	6	4	5	6	4	5	6	4	5	6
7	8	9	7	8	9	7	8	9	7	8	9	7	8	9
	0			0			0			0			0

CONTROLLER NO.: 4	CONTROLLER NO.: 3	CONTROLLER NO.: 2	CONTROLLER NO.: 1	CONTROLLER NO.: 1
Line termination: ON	Line termination: OFF	Line termination: OFF	Line termination: OFF	Line termination: ON

Daisy chain connection

●PS·Data Mode Connection

To apply the PS·Data mode, connect the system controllers as follows.

1.Connect the system controllers to the DATA 1 port of Video Output Board 1.

Notes:

•In the factory default, the DATA 1 port is set for the ter- minal mode connection. To apply the PS·Data mode connection, perform the DATA port settings in SETUP MENU (refer to p. 90) or WJ-SX650 Series Administrator Console.

•Both of terminal mode and PS·Data system controllers cannot be connected to the same DATA port.

•DATA 1 port of Video Output Board 2 cannot be set for the PS·Data connection.

•Up to 4 system controllers can be connected in the daisy chain. For system controllers in the daisy chain connection, operator registration is not available. (The same operator setting is applied for all the system con- trollers in the PS·Data daisy chain.)

2.Set the MODE switch of DATA ports connected to the system controllers to ON. (Switch #2: ON)

3.Set the system controllers to the PS·Data mode. (Refer to the operating instructions of system controllers.)

4.Set the line termination of system controllers with the MODE switches. (Refer to the operating instructions of system controllers.) In the daisy chain connection, set the line termination of chain end system controller to ON. (Switch #5: ON)

5.In the daisy chain connection, set the CONTROLLER NO. switches of system controllers to 1 to 4. The switch setting must be different from each other. (Refer to the operating instructions of system controller for details on the CONTROLLER NO. switch setting.)

Note: When using system controllers in the PS·Data mode, camera numbers that can be selected differ depending on system controller models.

Example:

WV-CU950/650: 1 to 999

WV-CU360C/CJ: 1 to 199

Select the system controller models that are applicable for your system composition. When using 200 or more cameras in the PS·Data mode, apply WV-CU950/650.

35