Panasonic WJ-SX650 manual Check if the alarm event has been set

Problem

Auto tracking ended before the end time of camera event setting.

Alarm event does not occur.

The image of camera associ- ated with the alarm event was not recorded.

The status before the alarm occurrence is not recovered, even though the alarm event is reset.

Alarm modes of connected devices are not reset even after the unit is powered off.

Cannot open SETUP MENU of the unit.

Check item and remedy				Reference
• Check if another camera event is not set for the camera.
			35
• Check if the alarm input signal setting is ON in ALARM of			86
SETUP MENU.
• Check if the alarm event has been set.	29
• Check if the deactivation period is scheduled for the alarm		90
event. (Check the alarm schedule setting.)
• Check if the alarm is not suspended and SETUP MENU is				16, 83
not open on the associated monitor.
• Check the connection and settings between the recorder and				–
the unit.
• Recording follows the recorder settings.				–
• Check the event recording setting of recorder.
• If an operator has activated a group sequence before the
alarm occurrence, and another operator reset the alarm or
performed operations on the monitor associated with the				–
group sequence, the status before the alarm occurrence is
not recovered.
• When you power off the unit, the alarm mode activated for
the unit is reset, but the alarm modes for the connected	32
devices are not reset. Power on the unit again, and perform
alarm reset.
• You cannot open SETUP MENU when another operator is				–
opening it.
• SETUP MENU cannot be displayed on a monitor associated				–
with an active alarm.

92