Panasonic AWHE60HE, AWHE60SN manual WwManually adjusting the gain, Press the OFF, LOW or HI button

Page 19

Manual shooting (continued)

wwManually adjusting the gain

There are two ways to adjust the gain. One way involves using the buttons on the wireless remote control or controller; the other way involves using the Camera menu or Web setting.

The gain can be adjusted more precisely using the Camera menu or Web setting.

For further details, refer to the [Gain] item on page 42 and page 72.

Note

ppWhen adjusting the gain, the light quantity may change suddenly (causing the image output to be subjected to a shock).

When performing the operations using the wireless remote control

1Press the [OFF], [LOW] or [HI] button.

These buttons enable the gain increase to be selected in three steps.

[LOW] is used to select 9 dB; [HI] is used to select 18 dB.

2If necessary, press the [AUTO] button in order to return the gain to the automatic adjustment (AGC).

When performing the operations using the controller

When the AWRP655 is connected:

1Press the [GAIN] button to turn off its lamp, and then switch to manual adjustment.

The preset gain increase amount is now selected.

For further details on the gain increase amount setting, refer to the Operating Instructions of the AWRP655.

2If necessary, press the [GAIN] button and turn on the button in order to return the gain to the automatic adjustment (AGC).

When the AWRP555 is connected:

1Press the [GAIN] button to turn off its lamp.

Each time this button is pressed, one of the three gain increase amounts can be selected in sequence.

The current status is displayed as follows.

 

[MANU]

[MANU]

[GAIN]

 

[L] lamp

[H] lamp

button

 

 

 

 

0 dB

Off

Off

Off

 

 

 

 

LOW

Lit

Off

Off

 

 

 

 

HIGH

Off

Lit

Off

 

 

 

 

AUTO

Off

Off

Lit

 

 

 

 

Other

Lit

Lit

Off

 

 

 

 

2If necessary, press the [GAIN] button several times and turn on its lamp in order to return the gain to the automatic adjustment (AGC).

When the AWRP50 is connected:

Refer to the Operating Instructions of the controller.

In any case, the maximum gain of the automatic adjustment can be set by the camera menu or Web setting.

For further details, refer to the [AGC Max Gain] item on page 42 and page 72.

19

Image 19
Contents AW‑HE60HN AW‑HE60SN AW‑HE60HE AW‑HE60SE Abbreviations Illustrations and screen displays featured in the manualTrademarks and registered trademarks About copyright and licenceContents WwOverview Before useWwRequired personal computer environment Usage restrictions WwDisclaimer of warrantyBefore use WwNetwork securityWwConcerning the plug-in viewer software 英語版 要入手Basic shooting operations Select the shooting modePp Power on preset How to turn the power on and offWwTurning the power on Set the Operate switch on the controller to onWwTurning the power off How to turn the power on and offSet the Operate switch on the controller to OFF Selecting the shooting modes scene files Selecting the unitsWwTypes of shooting modes Selecting the shooting modes scene files WwHow to select the shooting modeAW ‑RP655 display AW ‑HE60 scene file QqChanging the camera’s direction QqUsing the zoom functionQqSwitching the direction or zoom speed ShootingMenu screen is displayed Lens focus is not adjusted automaticallyUnit does not move Multiple color bands color bars are displayedMore advanced operations Manual shooting WwManually adjusting the focusManual shooting WwManually adjusting the irisWhen 50 Hz has been set as the unit’s frequency WwManually adjusting the shutter speedQq How to set the shutter speed using the AW‑RP555 When 59.94 Hz has been set as the unit’s frequencyPress the OFF, LOW or HI button WwManually adjusting the gainPress the Gain button to turn off its lamp Preset memories Hold down the Reset button Preset memoriesSet to the memory recording mode Set the memory recording modeWhen the AW‑RP555 is connected WwWhite balance adjustment White balance adjustmentQqAutomatic adjustment AWB AWB A or AWB B Press the SET button for 2 seconds White balance adjustmentPress the AWC button QqAuto tracking white adjustment ATW QqManual adjustment Gain and B gain adjustment Press the IRIS - button Black level master pedestal adjustmentWwBlack level master pedestal adjustment Press the M/IRIS buttonPress the Iris button several times to turn off its lamp Black level master pedestal adjustmentWwGenlock adjustment Genlock adjustment AW‑HE60S onlyQqHorizontal phase adjustment QqColor phase adjustment Genlock adjustment AW‑HE60S onlyPress the Mode button Genlock adjustment AW‑HE60S only Table of operations Basic operationsPrevious menu Basic operationsPress the  or  button to change the setting Jog dial L Jog dial mainJog dial R Press the Menu button to exit the camera menu QqProcedure for camera menu operation AW‑RP655Mode button lights up at the BAR setting Press the Menu button for 2 seconds to exit the camera menu QqProcedure for camera menu operation AW‑RP555Perform one of the following steps to select the menu item Press the Item buttonCamera OSD QqProcedure for camera menu operation AW‑RP50Camera menu items WwSetting the camera menu itemsWwTop Menu screen WwCamera screen When Manual1 to 3 is selected WwCamera screen When FullAuto is selectedCamera menu items WwContrast screen WwPicture 1/2 screen WwPicture 2/2 screen Ww16-axis color matrix WwGenlock screen AW‑HE60S only WwSystem screenSideCut Down CONV. Mode Squeeze, SideCut, LetterBoxWwOutput screen SqueezeFormat unchanged screen QqChanging the formatFormat change check screen Format Set screenWwOther 1/2 screen WwOther 2/2 screen WwFirmware Version screen WwMaintenance screenIP Address Default GatewayWwIP Network screen QqConcerning initializationCamera menu item table Factory setting Menu Selection items FullAuto Manual1RGB‑NOR, RGB‑ENH Camera menu item tableControls and settings from web screen Start the web browser of the personal computer Controls and settings from web screenWwDisplaying the web screen using a personal computer Operating system installed Web browserControls and settings from web screen  Compression button Compression WwLive screen Single display mode Multi-Screen list box Multi-screen  Image Capture Size button Image Capture Size Operation lock button Op.Lock  Power ON button / Standby button OSD Menu Operation  Camera button / Color bar button CAM/BAR Main area IP video display area  Control pad and its buttons  Preset Zoom  Focus Full-screen display  SnapShotWwLive screen Multi display mode QqBasic screen WwSetup screen Camera title display area Automatic installation of viewer software On, Off Basic button Camera title 0 to 20 half-size characters16 9 resize IP video settings Video over IP Video over IP Monitoring mode QqImage screenTransmission On, Off Jpeg image settingsImage settings Image capture size QVGA, VGARefresh interval Image capture size QVGA, VGA Initial setting VGAMulticast port 1024 to 50000 Only even numbers can be set Multicast address Setting range 224.0.0.0 toMulticast TTL/HOPLimit 1 to Preset position Image  Image Image adjust仕向地による違い Image adjust screen Scene FullAuto, Manual1, Manual2, Manual3  Contrast Contrast Mode Auto, ManualAWB  Picture Chroma Level -3 to +3Color Matrix Normal, EBU, NTSC, User User Color Matrix Setup screen Preset position setting screen  Preset  Zoom  Focus ADJ With PTZ  Speed With Zoom POS Limitation Setting  Preset Setting Preset Speed 1 toSystem screen  Genlock AW‑HE60S only Horizontal Phase -206 to +49 Frequency 59.94Hz, 50Hz  Output Other Images for which this setting is established QqMulti-screen Multi-screen setup  IP address To 128 half-size characters Camera title To 20 half-size characters QqUser mng  Host check Host auth. screen  Host auth  Access level Priority stream Activation Priority streamStream type QqServer Network screen  IP network QqNetworkPort numbers already used 20, 21, 23, 25, 42, 53, 67, 68 DNS Location 0 to 32 half-size characters Snmp screen Community 0 to 32 half-size characters  System name 0 to 32 half-size characters Time & date QqMaintenance Error description System log screen Serial no Product info. screen Model no  MAC address Status  Viewer software installation counter Reset to the default Except the network settings Default reset screen Reboot  Download Back up screen Upload  Pan/Tilt WpDisplaying the web screen using a mobile terminal Resolution switching  Iris  Tally lamp lighting status displays  Camera menu OSD menu operationSystem log displays NTP-related error displaysLogin-related displays Category Display Description of errorLimiters Press the Menu button Setting/releasing the limitersWwSetting the limiters WwBasic limiter operationsPp Releasing the upper limit position of the movement range Setting/releasing the limitersWwResetting the limiters WwReleasing the limitersWwConcerning the safe mode Safe modeTrouble-triggered safe mode WwTrademarks and Registered Trademarks WwSystem requirements for a personal computerSymptom WwPrecautions when using WindowsSolution 英語版必要 108 QqRestrictions109 Restriction 2 When using Windows 7 with some products Restriction 1 On the setup pages for some productsXxA XxF IndexXxN XxT IndexMemo Web Site http//panasonic.net Panasonic Corporation